tmnxPtpVRtrIfAdminState

The value of tmnxPtpVRtrIfAdminState specifies the administrative
state of the PTP hardware assist configuration of the interface.
              
If the value is 'inService(2)', the timestamp point for PTP event
packets is configured to be the physical layer.  This corresponds to
timestamp point 'A' in IEEE 1588-2008, Figure 14.
              
If the value is 'outOfService(3)', the timestamp point for PTP event
packets is configured to be the operating system kernel.  This
corresponds to timestamp point 'B' in IEEE 1588-2008, Figure 14.
              
The value may only be configured to 'inService(2)' if all of the
following are true:
1. An IPv4 address is configured against the interface.
2. An Ethernet physical port or link aggregation group (or VLAN tag on
   an Ethernet physical port or link aggregation group) has been
   associated with the interface.
3. The Ethernet port or all member ports of the link aggregation group
   associated with the interface must not be configured for WAN mode.
   In other words, the tmnxPortEtherXGigMode attribute for the port
   must be either 'notApplicable' or 'lan'.
4. The MDA associated with the interface has synchronous Ethernet
   enabled.  In other words, the tmnxMDASynchronousEthernet attribute
   for the MDA must be 'enabled'.
5. The port or every member port of the link aggregation group
   associated with the interface is on an IOM that supports the
   hardware assist configuration.
6. The port or every member port of the link aggregation group
   associated with the interface supports the hardware assist
   configuration.
7. The firmware currently in use by the active CPM support the hardware
   assist configuration.
8. The firmware currently in use by the IOM card supports the
   hardware assist configuration.  After an upgrade from an older
   release, the IOM may continue using older firmware.  A hard reset
   of the IOM is then needed to bring the IOM firmware up to date.
9. The firmware currently in use by the MDA supports the hardware
   assist configuration.  After an upgrade from an older release, the
   MDA may continue using older firmware.  A hard reset of the MDA or
   IOM is then needed to bring the MDA firmware up to date.
              
If the physical port bound to the interface is removed,
tmnxPtpVRtrIfAdminState is set to 'outOfService(3)'.
              
If the IPv4 address assigned to the interface is removed,
tmnxPtpVRtrIfAdminState is set to 'outOfService(3)'.

MIB

TIMETRA-PTP-MIB

OID

.1.3.6.1.4.1.6527.3.1.2.74.2.4.1.1

Type

column

Access

readwrite

Status

current

Parent

tmnxPtpVRtrIfEntry

Table

tmnxPtpVRtrIfTable