tmnxOamPmCfgThrDelayRaise

The value of tmnxOamPmCfgThrDelayRaise specifies the OAM-PM raise
threshold for excessive delay.
              
For example, suppose:
1.  tmnxOamPmCfgThrDelayRaise=1000 and tmnxOamPmCfgThrDelayLowestBin=7
for the index values 255, 'ifdv(3)', 'twoWay(3)'.
2.  Bin group 255 has been configured with 10 Inter-Frame Delay
Variation (IFDV) bins (numbered 0..9), using
tmnxOamPmCfgBinGroupIfdvBinCount.
3.  The OAM-PM session 'oamPmSession1' is configured to use bin group
255 (using tmnxOamPmCfgSessBinGroupId).
4.  OAM-PM delay TCAs are enabled for the measurement interval with
indices 'oamPmSession1', 'mi15Minutes(2)' (using
tmnxOamPmCfgMeasIntvlDelayTCAs and tmnxOamPmCfgMeasIntvlTCAs).
5.  During a 15 minute interval belonging to a DMM test which belongs
to 'oamPmSession1', the following inequality becomes true (where only
the last two indices of the object are shown, and the last index is a
bin number):
   tmnxOamPmStsDelayDmmBin2wyCount.ifdv(3).7 +
   tmnxOamPmStsDelayDmmBin2wyCount.ifdv(3).8 +
   tmnxOamPmStsDelayDmmBin2wyCount.ifdv(3).9 >= 1000
              
Then, a delay Raise TCA (using tmnxOamPmThrRaise) will be generated
immediately.
              
The TCA suppression and configuration rules for
tmnxOamPmCfgThrDelayRaise and tmnxOamPmCfgThrDelayClear are the same
as the rules for tmnxOamPmCfgThrLossChliRaise and
tmnxOamPmCfgThrLossChliClear.
              
The upper bound of this object is the maximum number of DMM PDUs (or
TWAMP-Test PDUs) which can be sent in the longest supported (i.e. 24
hour) measurement interval.

MIB

TIMETRA-OAM-PM-MIB

OID

.1.3.6.1.4.1.6527.3.1.2.92.1.3.15.1.3

Type

column

Access

readwrite

Status

current

Parent

tmnxOamPmCfgThrDelayEntry

Table

tmnxOamPmCfgThrDelayTable

Siblings

4