swSafeGuardmode

SAFEGUARD-ENGINE-MIB · .1.3.6.1.4.1.171.12.19.2.3

Object

scalar r/w Enumeration

determine the controlling method of broadcast traffic.
Here are two modes (strict and fuzzy). In strict,
the Switch will stop receiving all 'ARP not to me' packets (the protocol
address of target in ARP packet is the Switch itself). That means no matter
what reasons cause the high CPU utilization (may not caused by ARP storm),
the Switch reluctantly processes any 'ARP not to me' packets in exhausted mode.
In fuzzy mode, the Switch will adjust the bandwidth dynamically depend on some
reasonable algorithm.

Context

MIB: SAFEGUARD-ENGINE-MIB
OID: .1.3.6.1.4.1.171.12.19.2.3
Type: scalar
Access: readwrite
Status: current
Parent: swSafeGuardctrl
Siblings: 5

Syntax

Enumeration

Values & Constraints

Enumerated Values

`1`	strict
`2`	fuzzy

Related Objects

Sibling Objects

Object	Type	Syntax	OID
swSafeGuardRisingThreshold The object indicates CPU protection rising threshold in percentage. the range is between 20%-100% , if the CPU utilization is over the rising threshold, the switch enters exhauste…	scalar	Integer32	`.1.3.6.1.4.1.171.12.19.2.1`
swSafeGuardFallingThreshold The object indicates CPU protection falling threshold in percentage. the range is between 20%-100% , if the CPU utilization is lower than the falling threshold, the switch enters …	scalar	Integer32	`.1.3.6.1.4.1.171.12.19.2.2`
swSafeGuardAlarmAdminState This object indicates the state of cpu protection related trap/log mechanism (enable or disable). If set to enable, trap and log will be active while cpu protection current mod…	scalar	Enumeration	`.1.3.6.1.4.1.171.12.19.2.4`
swSafeGuardCurrentStatus This object indicates current operation mode of Safe Guard	scalar	Enumeration	`.1.3.6.1.4.1.171.12.19.2.5`
swSafeGuardInterval The object indicates CPU utilization monitor interval in seconds. The range is between 5 to 10, default value is 5.	scalar	Integer32	`.1.3.6.1.4.1.171.12.19.2.6`