saPUFScanAllNow
SA-CM-MIB ·
.1.3.6.1.4.1.1429.77.1.10.4
Object
Setting this object to true(1) causes the modem to immediately go offline and scan all the frequencies stored in the saPUFFrequency table. Results and timestamp of the scan are stored to non-vol. After the scan takes place the modem re-inits the CM mac and re-registers. Conditions to run the scan: - saPUFRowStatus.x must be set to active for a scan to take place for that frequency. - The scan will not take place if a provisioned line is offhook. - If this mib is added to the CM config file, a scan will not take place unless the current time from TOD server is > 360 seconds (6 minutes) from the last scan time stored in saPUFScanTimestamp.x. This mib object returns false(2)when read if no scan was initiated.
Values & Constraints
Type Values
1 | true |
2 | false |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| saPUFTable A table of PowerUp Frequencies scanned first. | table | - | .1.3.6.1.4.1.1429.77.1.10.1 |
| saPUFTrapServer Defines the IP address of the server to send SNMP traps after running a scan.
This value is stored in non-volatile memory. | scalar | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.1429.77.1.10.2 |
| saPUFTrapControl Send a trap:
- If RF energy is detected - enableOnEnergyDetection(1),
- If RF energy is not detected - enableOnNoEnergyDetected(2),
- When a scan is run - enableOnFrequencyScan(3)… | scalar | Enumeration | .1.3.6.1.4.1.1429.77.1.10.3 |
| saPUFEntriesClearOnRFD By Default, reset to factory default (RFD) would clear all the PUF entries to factory values.
Setting this value to false(2) would mean that the saPUF table frequencies would not… | scalar | SNMPv2-TCTruthValue | .1.3.6.1.4.1.1429.77.1.10.5 |