dot5RingStatus

RFC1231-MIB · .1.3.6.1.2.1.10.9.1.1.3

Object

column mandatory Integer32

The current interface status which can
be used to diagnose fluctuating problems
that can occur on token rings, after a
              
              
              
              
              
station has successfully been added to
the ring.
   Before an open is completed, this
object has the value for the 'no status'
condition.  The dot5RingState and
dot5RingOpenStatus objects provide for
debugging problems when the station
can not even enter the ring.
    The object's value is a sum of
values, one for each currently applicable
condition.  The following values are
defined for various conditions:
              
        0 = No Problems detected
       32 = Ring Recovery
       64 = Single Station
      256 = Remove Received
      512 = reserved
     1024 = Auto-Removal Error
     2048 = Lobe Wire Fault
     4096 = Transmit Beacon
     8192 = Soft Error
    16384 = Hard Error
    32768 = Signal Loss
   131072 = no status, open not completed.

Context

MIB: RFC1231-MIB
OID: .1.3.6.1.2.1.10.9.1.1.3
Type: column
Access: readonly
Status: mandatory
Parent: dot5Entry
Table: dot5Table
Siblings: 8

Syntax

Integer32

Source: COPS-PR-SPPIInteger32
Base type: Integer32

Values & Constraints

Type Constraints

range: -2147483648..2147483647

Related Objects

Sibling Objects

Object	Type	Syntax	OID
dot5IfIndex mandatory The value of this object identifies the 802.5 interface for which this entry contains management informa…	column	Integer32	`.1.3.6.1.2.1.10.9.1.1.1`
dot5Commands mandatory When this object is set to the value of open(2), the station should go into the open state. The progress and success of the open is given by the values of the objects dot5RingSta…	column	Enumeration	`.1.3.6.1.2.1.10.9.1.1.2`
dot5RingState mandatory The current interface state with respect to entering or leaving the ring.	column	Enumeration	`.1.3.6.1.2.1.10.9.1.1.4`
dot5RingOpenStatus mandatory This object indicates the success, or the reason for failure, of the station's most recent attempt to enter the ring.	column	Enumeration	`.1.3.6.1.2.1.10.9.1.1.5`
dot5RingSpeed mandatory The ring's bandwidth.	column	Enumeration	`.1.3.6.1.2.1.10.9.1.1.6`
dot5UpStream mandatory The MAC-address of the up stream neighbor station in the ring.	column	MacAddress	`.1.3.6.1.2.1.10.9.1.1.7`
dot5ActMonParticipate mandatory If this object has a value of true(1) then this interface will participate in the active monitor selecti…	column	Enumeration	`.1.3.6.1.2.1.10.9.1.1.8`
dot5Functional mandatory The bit mask of all Token Ring functional addresses for which this interface will accept frames.	column	MacAddress	`.1.3.6.1.2.1.10.9.1.1.9`