swPackActivityState

RAD-SwPack-MIB · .1.3.6.1.4.1.164.6.2.67.4.1.1.2

Object

column Enumeration
SW Pack activity states are:
active (1) - is set upon SW Pack installation starting
    process.
    Only one SW Pack may be 'active' at any given time.
    When a SW Pack becomes 'active' agent sets 'readOnly'
    bit of the fileSystemEntry.fileSystemValidIndication
    object.
    In addition the agent shall mark the previous active SW
    Pack to 'previousActive' (see below description of
    'previousActive (3)').
ready (2) - means that the SW Pack was loaded successfully
    and it is ready to be installed. The 'readOnly' bit of
    the fileSystemEntry.fileSystemValidIndication object
    shall be reset.
previousActive (3)- This is a transitional status that
    remains during the installation process. After the
    completion of the installation the Agent changes it to
    'ready'. In case of SW Pack installation interruption by
    the 'undoInstall' command the agent shall change the
    'previousActive' state to 'active'.
    Note: Only one previousActive SW Pack may exist at any
    given time.

Context

MIB
RAD-SwPack-MIB
OID
.1.3.6.1.4.1.164.6.2.67.4.1.1.2
Type
column
Access
readonly
Status
current
Parent
swPackEntry
Table
swPackTable
Siblings
3

Syntax

Enumeration

Values & Constraints

Enumerated Values
1active
2ready
3previousActive

Related Objects

Sibling Objects