pwGenUdpMuxMethod
RAD-Pw-MIB ·
.1.3.6.1.4.1.164.14.1.1.1.1.21
Object
column
r/w
Enumeration
This objects defines the method in which the UDP header is used
to multiplex between different PWs, as follows:
sourcePort - validate the destination port value
and perform internal routing according to the source port
(RAD's old implementation).
destinationPort - the configured destination port,
together with both the source and destination IP addresses,
uniquely identifies the PW for the receiver (standard method).
It is applicable only when pwPsnType= ip(3).
Context
- MIB
- RAD-Pw-MIB
- OID
.1.3.6.1.4.1.164.14.1.1.1.1.21- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- pwGenEntry
- Table
- pwGenTable
- Siblings
- 24
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | notApplicable |
2 | sourcePort |
3 | destinationPort |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| pwIdx Index of this table.
The value for this object is equal to the value
of pwIndex from the pwTable of PW-STD-MIB | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.164.14.1.1.1.1.1 |
| pwGenIpNextHop This object defines local Next Hop IP Address for this PW.
0.0.0.0 - means - not applicable.
This object is applicable only when pwGenNextHopType=ipV4 | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.164.14.1.1.1.1.10 |
| pwGenMacNextHop This object defines local Next Hop MAC Address for this PW.
0:0:0:0:0:0 - means - not applicable.
This object is applicable only when pwGenNextHopType=bridgePort | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.164.14.1.1.1.1.11 |
| pwGenEnableVlanTag This object enables or disables a VLAN tag on
every transmitted packet via this PW connection | column | Enumeration | .1.3.6.1.4.1.164.14.1.1.1.1.12 |
| pwGenVlanId This object indicates the VLAN ID tag attached
to every transmitted packet via this PW connection.
This entry is applicable only if pwGenEnableVlanTag=enabled(3). | column | Unsigned32 | .1.3.6.1.4.1.164.14.1.1.1.1.13 |
| pwGenVlanPriority This object indicates the VLAN priority assigned
to every transmitted packet via this PW connection.
This entry is applicable only if pwGenEnableVlanTag=enabled(3) | column | Unsigned32 | .1.3.6.1.4.1.164.14.1.1.1.1.14 |
| pwGenIpTos This object indicates TOS field value
for PW having pwPsnType= ip(3) | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.164.14.1.1.1.1.15 |
| pwGenSourceUdpPort This object indicates source UDP port (1...65535) value
for pw having pwPsnType= ip (3) | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.164.14.1.1.1.1.16 |
| pwGenSubType This object indicates the PW Sub Type
(i.e. Sub Type of 'pwType' from 'pwTable').
For ACE-3000 devices:
It is applicable only when pwType = basicCesPsn(21). | column | Enumeration | .1.3.6.1.4.1.164.14.1.1.1.1.17 |
| pwGenSourceIpAddress Source IP Address per PW | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.164.14.1.1.1.1.18 |
| pwGenSourceIpMask Source IP Mask per PW | column | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.164.14.1.1.1.1.19 |
| pwGenPeerIdx This object indicates the Index of the Peer
(as it is defined in the Peer Table), which terminated this PW. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.164.14.1.1.1.1.2 |
| pwGenOamStatus This objects indicates the status of the PW OAM:
disabled - the PW is shutdown and/or OAM is disabled for the PW.
connected - OAM is enabled and is synchronized with the peer
… | column | Enumeration | .1.3.6.1.4.1.164.14.1.1.1.1.23 |
| pwGenMismatchReason This object details the PW configuration mismatch. | column | Enumeration | .1.3.6.1.4.1.164.14.1.1.1.1.24 |
| pwGenOamDelayThreshold This objects defines a Delay Threshold in microseconds
when this value is exceeded an event is sent. (used as rising threshold)
Rising threshold range of values is between 1-180 m… | column | microseconds SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.164.14.1.1.1.1.27 |
| pwGencasFramesPerPacket This objects defines the Frames Per Packet:
4 - E1/T1 frames per packet, packetization delay of 0.5 m.s.
8 - E1/T1 frames per packet, packetization delay of 1 m.s.
12 - T1 frame… | column | Unsigned32 | .1.3.6.1.4.1.164.14.1.1.1.1.28 |
| pwGenOamDelayThresholdFalling This objects defines a PW OAM Delay falling Threshold
in microseconds units. When delay reach below this value, event is cleared.
Falling threshold range of values is between 1-18… | column | microseconds SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.164.14.1.1.1.1.29 |
| pwGenAttachmentCircuit This is a unique index within the ifTable. It represents
the attached circuit interface (e.g ATM VC, HDLC) attached to
this PW connection (from service initiator side).
… | column | IF-MIBInterfaceIndexOrZero | .1.3.6.1.4.1.164.14.1.1.1.1.3 |
| pwGenOutgoingInterface This is a unique index within the ifTable. It represents
the outgoing interface (towards the PSN ) attached to
this PW connection.
This object is applicable only wh… | column | IF-MIBInterfaceIndexOrZero | .1.3.6.1.4.1.164.14.1.1.1.1.4 |
| pwGenOamMode This objects defines whether OAM will be enabled on this PW.
notApplicable(1) value will be used when
PW type does not support OAM. | column | Enumeration | .1.3.6.1.4.1.164.14.1.1.1.1.5 |
| pwGenOamType This objects defines the failure detection mechanism used
on this PW.
BFD - Bidirectional Forwarding Detection
notApplicable(1) value will be used when
pwGenOamMode is notApplica… | column | Enumeration | .1.3.6.1.4.1.164.14.1.1.1.1.6 |
| pwGenSequenceNumberField This object defines whether processing of Sequence Number field
(ATM cell encapsulation) will be done by device, on this PW. | column | Enumeration | .1.3.6.1.4.1.164.14.1.1.1.1.7 |
| pwGenNextHopType Indicates address type of the Next Hop.
Not applicable for device with router. | column | Enumeration | .1.3.6.1.4.1.164.14.1.1.1.1.8 |
| pwGenNextHop Not applicable (=0) when pwMplsEgressTunnelNextHopType=notApplicable.
When applicable, represents ATM VC, Bridge Port,
according to pwMplsEgressTunnelNextHopType. | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.164.14.1.1.1.1.9 |