internalVirtualSwitchEnable

MX-VM-MIB · .0.4500.1.100.200
MIB view Table view

Object

scalar r/w MX-TCMxEnableState 
Internal Virtual Switch Enable
          
Specifies if an internal virtual network interface ? also
known as a host-only virtual switch - should be created
between the VM(s) and the host.
          
  * Disable: No internal virtual network interface.
  * Enable: An internal virtual network interface is created
    with the address and subnet mask specified in the
    InternalVirtualLinkIpAddr parameter.
          
When enabled, the internal virtual switch is listed after the
'external' virtual switches in the VM(s).
          
This internal virtual switch only enables internal
communications on a known subnet, and does not depend on the
state of the physical network ports. To allow external
communications in the VM(s), see the
Eth.LinksTable.LinksVirtualSwitch parameters.

Context

MIB
MX-VM-MIB
OID
.0.4500.1.100.200
Type
scalar
Access
readwrite
Status
current
Parent
configGroup
Siblings
2

Syntax

MX-TCMxEnableState
Source
MX-TCMxEnableState
Base type
Enumeration

Values & Constraints

Type Values
0disable
1enable

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
vmTable
Virtual Machine Config This table contains the parameters used to configure the VMs. The changes to this table are applied on execution of the VM.StartVm com…
table-.0.4500.1.100.100
internalVirtualSwitchIpAddr
Internal Virtual Switch IP Address Specifies the IP address and subnet mask to use on the host when the InternalVirtualSwitchEnable parameter is set to enable.
scalarMX-TC2MxIpAddrMask.0.4500.1.100.300