genEquipInterfacesEtherDefaultVLANId
MWRM-NETWORK-MIB ·
.1.3.6.1.4.1.2281.10.9.1.1.1.14
Object
column
r/w
Integer32
Default VLAN ID of the Ethernet interface.
Context
- MIB
- MWRM-NETWORK-MIB
- OID
.1.3.6.1.4.1.2281.10.9.1.1.1.14- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- genEquipInterfacesEtherEntry
- Table
- genEquipInterfacesEtherTable
- Siblings
- 14
Syntax
Integer32
Values & Constraints
Object Constraints
range: 1-4090
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| genEquipInterfacesEtherConnType The physical interface type. For port 8 the only valid value is radio. For ports 3 to 7 the only valid
value is rj45. | column | Enumeration | .1.3.6.1.4.1.2281.10.9.1.1.1.1 |
| genEquipInterfacesEtherActualRate Actual rate (in auto-negotiation, the rate the two ports agreed upon) - 10, 100 OR 1000 Mbps. | column | MWRM-UNIT-MIBRateMbps | .1.3.6.1.4.1.2281.10.9.1.1.1.10 |
| genEquipInterfacesEtherClkSrc The source for the outgoing carrier signal clock. Local-clock is an internal independent oscilator.
system-clock-source causes the ethernet clock to be derived from the defined sy… | column | Enumeration | .1.3.6.1.4.1.2281.10.9.1.1.1.11 |
| genEquipInterfacesEtherPortServiceType This parameter indicates whether the port is being used as a Service Access Point (SAP)
or as a Service Network Point (SNP) in a network-wide Ethernet service;
the parameter has n… | column | Enumeration | .1.3.6.1.4.1.2281.10.9.1.1.1.12 |
| genEquipInterfacesEtheMACAddress The MAC address of the port for CFM or PWE3 addressing purposes. | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.2281.10.9.1.1.1.13 |
| genEquipInterfacesEtherPortBlockSharedVlans When enabled, this parameter blocks transfer of Ethernet frames to/from other ports
for which it is enabled, effectively eliminating all shared VLANs. | column | MWRM-UNIT-MIBEnableDisable | .1.3.6.1.4.1.2281.10.9.1.1.1.15 |
| genEquipInterfacesEtherPortType The type of the port.
Access - untagged port (in case of managed switch).
Trunk - C-VID tagged port (in case of managed switch).
CN - Don't care on the vlan tag (in case of metro … | column | Enumeration | .1.3.6.1.4.1.2281.10.9.1.1.1.2 |
| genEquipInterfacesEtherAutoNegotiation Enable or disable auto-negotiation on the port. | column | Enumeration | .1.3.6.1.4.1.2281.10.9.1.1.1.3 |
| genEquipInterfacesEtherDuplex Half or full duplex. | column | MWRM-UNIT-MIBHalfFull | .1.3.6.1.4.1.2281.10.9.1.1.1.4 |
| genEquipInterfacesEtherRate 10, 100 OR 1000 Mbps. | column | MWRM-UNIT-MIBRateMbps | .1.3.6.1.4.1.2281.10.9.1.1.1.5 |
| genEquipInterfacesEtherPortLerningAdmin Enable or disable MAC address learning in the port. | column | Enumeration | .1.3.6.1.4.1.2281.10.9.1.1.1.6 |
| genEquipInterfacesEtherFlowCtrl Enable or disable flow control on the port. Supported only in pipe mode. | column | Enumeration | .1.3.6.1.4.1.2281.10.9.1.1.1.7 |
| genEquipInterfacesEtherLagPortMember The syntax is ifIndex, or FFFF for port that is not member in a lag. | column | Enumeration | .1.3.6.1.4.1.2281.10.9.1.1.1.8 |
| genEquipInterfacesEtherActualDuplex Actual duplex (in auto-negotiation, the mode the two ports agreed upon) - Half or full duplex. | column | MWRM-UNIT-MIBHalfFull | .1.3.6.1.4.1.2281.10.9.1.1.1.9 |