genEquipInterfacesASPRemoteFault

MWRM-NETWORK-MIB · .1.3.6.1.4.1.2281.10.9.6.5
MIB view Table view

Object

scalar r/w MWRM-UNIT-MIBEnableDisable 
This parameter enables/disables automatic state propagation.
The following remote faults are propagated to the NE by default:
- Radio LOF
- Radio link ID mismatch
- Ethernet line LOC
any other remote faults are propagated to the NE only if they are
enabled at the local NE

Context

MIB
MWRM-NETWORK-MIB
OID
.1.3.6.1.4.1.2281.10.9.6.5
Type
scalar
Access
readwrite
Status
current
Parent
genEquipInterfacesASP
Siblings
5

Syntax

MWRM-UNIT-MIBEnableDisable
Source
MWRM-UNIT-MIBEnableDisable
Base type
Enumeration

Values & Constraints

Type Values
2enable
3disable

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
genEquipInterfacesASPAdmin
Controls the Automatic State Propagation
scalarMWRM-UNIT-MIBEnableDisable.1.3.6.1.4.1.2281.10.9.6.1
genEquipInterfacesASPLocalLOC
Enables fault propagation upon detection of local LOC. This configuration is relevant only for non-protected single-pipe switch mode only.
scalarMWRM-UNIT-MIBEnableDisable.1.3.6.1.4.1.2281.10.9.6.2
genEquipInterfacesASPLocalExcessiveBER
Enables fault propagation to the Ethernet interface upon detection of radio excessive BER. This configuration is relevant only for non-protected single-pipe switch mode only.
scalarMWRM-UNIT-MIBEnableDisable.1.3.6.1.4.1.2281.10.9.6.3
genEquipInterfacesASPACMthreshold
Enable or disable the propagation when Radio ACM profile degrades below a defined profile. This configuration is relevant only for non-protected single-pipe switch mode only when …
scalarEnumeration.1.3.6.1.4.1.2281.10.9.6.4
genEquipInterfacesNGASPnode-.1.3.6.1.4.1.2281.10.9.6.7