juniSonetMediumLoopbackConfig
Juniper-UNI-SONET-MIB ·
.1.3.6.1.4.1.4874.2.2.7.1.1.1.2
Object
column
r/w
Enumeration
The current loopback state of the SONET/SDH interface.
The values mean:
sonetNoLoop Not in the loopback state. A device that is not
capable of performing a loopback on this
interface shall always return this value.
sonetFacilityLoop The received signal at this interface is looped
back out through the corresponding transmitter in
the return direction.
sonetTerminalLoop The signal that is about to be transmitted is
connected to the associated incoming receiver.
sonetOtherLoop Loopbacks that are not defined here.
Context
- MIB
- Juniper-UNI-SONET-MIB
- OID
.1.3.6.1.4.1.4874.2.2.7.1.1.1.2- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- juniSonetMediumEntry
- Table
- juniSonetMediumTable
- Siblings
- 5
Syntax
Enumeration
Values & Constraints
Enumerated Values
0 | sonetNoLoop |
1 | sonetFacilityLoop |
2 | sonetTerminalLoop |
3 | sonetOtherLoop |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| juniSonetMediumType deprecated This variable identifies whether a SONET or a SDH signal is used across
this interface. This object was deprecated because the same information
is provided by the SONET-MIB.sonet… | column | Enumeration | .1.3.6.1.4.1.4874.2.2.7.1.1.1.1 |
| juniSonetMediumTimingSource Selects the source from which transmit timing is derived.
loop timing is recovered from the receiver
internalModule timing is from the module associated with this
… | column | Enumeration | .1.3.6.1.4.1.4874.2.2.7.1.1.1.3 |
| juniSonetMediumCircuitIdentifier deprecated This variable contains the transmission vendor's circuit identifier,
for the purpose of facilitating troubleshooting. This object was
deprecated because the same information is p… | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.4874.2.2.7.1.1.1.4 |
| juniSonetMediumTriggerAlarms The alarms that are used in the operational status calculation for this
SONET interface.
sectionLOS When this bit is set, section LOS is used for
operational … | column | Bits | .1.3.6.1.4.1.4874.2.2.7.1.1.1.5 |
| juniSonetMediumTriggerDelay The time delay (in milliseconds) before a defect is accepted as an
alarm for this SONET interface. | column | ms Integer32 | .1.3.6.1.4.1.4874.2.2.7.1.1.1.6 |