deviceRunts
IRM3-MIB ·
.1.3.6.1.4.1.52.1.2.1.1.13
Object
The number of runt frames detected by this device.
Syntax
RFC1155-SMICounter
- Source
- RFC1155-SMICounter
- Base type
Unsigned32
Values & Constraints
Type Constraints
range: 0..4294967295
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| deviceRecColls mandatory The number of receive collisions detected by this MMAC. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.10 |
| deviceAlignErrs mandatory The number of packets with alignment errors detected. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.11 |
| deviceCRCErrs mandatory The number of packets with bad CRC detected. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.12 |
| deviceOOWColls mandatory The number of out-of-window collisions detected by this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.14 |
| deviceNoResources mandatory The number of No resource condtions detected by this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.15 |
| deviceRecBytes mandatory The number of bytes detected on the network. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.16 |
| deviceGiantFrames mandatory The number of packets longer than 1518 bytes. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.17 |
| deviceRestart mandatory If this object is set to 1 the device is restarted. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.18 |
| deviceResetCounters mandatory If this object is set to 1, all of the devices counters are reset
to 0. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.19 |
| deviceMMACType mandatory Indicates the type of MMAC. | scalar | Enumeration | .1.3.6.1.4.1.52.1.2.1.1.2 |
| deviceRedundantCts mandatory The number of redundant circuits available for use. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.20 |
| deviceDiscover obsolete When this variable is set to 1 The following events occur:
(1) The device sends a LINK-UP trap
(2) The device sends a proprietary packet that will
cause all other Cabeltron… | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.21 |
| deviceTimeBase mandatory The number of seconds used as the interval for performing all of
the rate alarm checks. The minimum is 10 secs. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.24 |
| deviceResetRedundancy mandatory Setting this object to a 1 will reset redundancy for the entire box. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.25 |
| deviceSrcAddrAgingTime mandatory The number of minutes that a source address is not detected before it
is removed from the source address table. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.26 |
| deviceSrcAddrTraps mandatory Controls sending of source address related traps. | scalar | Enumeration | .1.3.6.1.4.1.52.1.2.1.1.27 |
| deviceSrcAddrLocked mandatory If this is set to 2, any source addresses that are detected on
station ports that are not in the table will cause the port to
be turned off. | scalar | Enumeration | .1.3.6.1.4.1.52.1.2.1.1.28 |
| deviceEtherOccupiedSlots mandatory The slots that contain Ethernet MIM boards. This field
is bit encoded (eg. if a bit is set then that board is present).
For example, a value of 2 indicates that there is an Ether… | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.29 |
| deviceSlots mandatory Number of available device slots in this device, including the
IRM slot. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.3 |
| deviceTROccupiedSlots mandatory The slots that contain managable Token Ring MIM boards. This
field is bit encoded (eg. if a bit is set then that board is
present). For example, a value of 2 indicates that ther… | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.30 |
| deviceFDDIOccupiedSlots mandatory The slots that contain FDDI MIM boards. This field is bit encoded
(eg. if a bit is set then that board is present). For example, a
value of 2 indicates that there is an FDDI boa… | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.31 |
| deviceRestoreDefaults mandatory If this object is set to 1 the factory defaults are restored. This,
however, does not affect the device's IP address. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.32 |
| deviceActiveUsers mandatory The number of active users seen by this device. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.33 |
| deviceOSIFrames mandatory The number of frames with OSI protocol seen by this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.34 |
| deviceNovellFrames mandatory The number of frames with NOVELL protocol seen by this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.35 |
| deviceBanyanFrames mandatory The number of frames with BANYAN protocol seen by this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.36 |
| deviceDECNetFrames mandatory The number of frames with DECNET protocol seen by this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.37 |
| deviceXNSFrames mandatory The number of frames with XNS protocol seen by this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.38 |
| deviceIPFrames mandatory The number of frames with TCPIP protocol seen by this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.39 |
| deviceOccupiedSlots mandatory The slots that contain MIM boards. This field is bit encoded (eg.
if a bit is set then that board is present). For example, a value
of 3 indicates that there are boards in t… | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.4 |
| deviceCtronFrames mandatory The number of frames with Cabletron protocol seen by this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.40 |
| deviceAppletalkFrames mandatory The number of frames with Appletalk protocol seen by this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.41 |
| deviceOtherFrames mandatory The number of frames seen by this device, that do not fall into
any of the previously listed protocol catagories. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.42 |
| device64To127Frames mandatory The number of frames seen by this device, with frame sizes between
64 and 127 bytes. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.43 |
| device128To255Frames mandatory The number of frames seen by this device, with frame sizes between
128 and 255 bytes. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.44 |
| device256To511Frames mandatory The number of frames seen by this device, with frame sizes between
256 and 511 bytes. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.45 |
| device512To1023Frames mandatory The number of frames seen by this device, with frame sizes between
512 and 1023 bytes. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.46 |
| device1024To1518Frames mandatory The number of frames seen by this device, with frame sizes between
1024 and 1518 bytes. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.47 |
| deviceBroadPkts mandatory The sum of broadcast packets detected on all ports of this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.48 |
| deviceMultPkts mandatory The sum of multicast packets detected on all ports of this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.49 |
| devicePortsOn mandatory The number of operating ports on the device. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.5 |
| deviceThdPartyOccupiedSlots mandatory The slots that contain Third Party MIM boards. This field
is bit encoded (eg. if a bit is set then that board is present).
For example, a value of 2 indicates that there is a Th… | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.51 |
| deviceImimOccupiedSlots mandatory The slots that contain Cabletron Intelligent MIM boards. This field
is bit encoded (eg. if a bit is set then that board is present).
For example, a value of 2 indicates that ther… | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.52 |
| deviceLinkTraps mandatory Controls sending of link related traps. | scalar | Enumeration | .1.3.6.1.4.1.52.1.2.1.1.54 |
| ctIPDefaultFrameType mandatory Defines the default frame type that will be used by the
device. A device will understand both frame types and will
respond based upon the framing type that is learned for
the giv… | scalar | Enumeration | .1.3.6.1.4.1.52.1.2.1.1.56 |
| deviceSrcAddrType mandatory Selects the hashing algorithm of source addresses, DEC or IP | scalar | Enumeration | .1.3.6.1.4.1.52.1.2.1.1.57 |
| deviceTotalPorts mandatory The total number of repeater ports on the MMAC. | scalar | Integer32 | .1.3.6.1.4.1.52.1.2.1.1.6 |
| deviceTotalPkts mandatory The number of packets detected on all ports of this device. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.7 |
| deviceTotalErrors mandatory The sum of all of the errors listed including alignment, CRC, runts,
giants, and out of window collisions. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.8 |
| deviceTransmitColls mandatory The number of transmit collisions detected by this MMAC. | scalar | RFC1155-SMICounter | .1.3.6.1.4.1.52.1.2.1.1.9 |