hpicfHAContinuousFwdingTime – HpicfHighAvailability-MIB

Object

scalar r/w seconds SNMPv2-SMIUnsigned32

This is a configurable timer. After the failover, on the new AMM, 
the route and neighbor table entries are marked as stale in the FIB. 
As routing protocols begin to re-add routes, this stale flag 
will be reset. When this timer expires, all route and neighbor
table entries still marked stale [not yet re-added] will be
removed. A value of 0 means that no layer 3 hitless behavior is desired, 
and in this configuration, upon failover all FIB entries are 
flushed and corresponding hardware entries are removed. 
A default value of 5 minutes is chosen with the assumption
that the routing protocols can finish re-adding the routes to 
the equivalent state within this time.

Context

MIB: HpicfHighAvailability-MIB
OID: .1.3.6.1.4.1.11.2.14.11.1.11.1.2
Type: scalar
Access: readwrite
Status: current
Units: seconds
Parent: hpicfHAConfigObjects
Siblings: 2

Syntax

seconds SNMPv2-SMIUnsigned32

Source: SNMPv2-SMIUnsigned32
Base type: Unsigned32

Values & Constraints

Type Constraints

range: 0..4294967295

Related Objects

Sibling Objects

Object	Type	Syntax	OID
hpicfHARedundancyManagementModuleMode Specify to enable/disable this feature. Enabling allows for management module redundancy when there are two management modules in the switch and does a hitless failover. Disabling…	scalar	Enumeration	`.1.3.6.1.4.1.11.2.14.11.1.11.1.1`
hpicfHAPreferredActiveManagement Specify management module priority to specify Active management module across several reboot. The module is likely to become Active post reboot and Not instantaneously. The settin…	scalar	Enumeration	`.1.3.6.1.4.1.11.2.14.11.1.11.1.3`