gBondPortConfTargetUpDataRate

A desired G.Bond port data rate in the upstream direction,
in Kbps, to be achieved during initialization, under
restrictions placed upon the member BCEs by their respective
configuration settings.
This object represents a sum of individual BCE upstream data
rates, modified to compensate for fragmentation and
encapsulation overhead (e.g., for an Ethernet service, the
target data rate of 10 Mbps SHALL allow lossless transmission
of full-duplex 10-Mbps Ethernet frame stream with minimal
inter-frame gap).
Note that the target upstream data rate may not be achieved
during initialization (e.g., due to unavailability of required
BCEs) or the initial bandwidth could deteriorate, so that the
actual upstream data rate (gBondPortStatUpDataRate) could be less
than gBondPortConfTargetUpDataRate.
              
The value is limited above by 10 Gbps, to accommodate very
high speed bonded xDSL interfaces (e.g., 32 x 100 Mbps).
              
The value between 1 and 10000000 indicates that the total
upstream data rate of the G.Bond port after initialization
SHALL be equal to the target data rate or less, if the target
upstream data rate cannot be achieved under the restrictions
configured for BCEs.  In cases where the copper environment
allows a higher upstream data rate to be achieved than that
specified by this object, the excess capability SHALL be
either converted to an additional SNR margin or reclaimed by
minimizing transmit power.
              
The value of 0 means that the target data rate is not
fixed and SHALL be set to the maximum attainable rate during
initialization (best effort), under specified spectral
restrictions and with a desired SNR margin per BCE.
              
This object is read-write for the -O subtype G.Bond ports.
It is irrelevant for the -R subtypes -- attempts to read or
change this object for such ports MUST be rejected (in the case
of SNMP, with the error inconsistentValue).
              
Changing of the target upstream data rate MUST be performed
when the link is administratively 'down', as indicated by the
ifAdminStatus object in the IF-MIB.
Attempts to change this object MUST be rejected (in the case of
SNMP, with the error inconsistentValue), if the link is 'up' or
initializing.
              
This object maps to the TR-159 attribute aGroupTargetUpRate.

MIB

GBOND-MIB

OID

.1.3.6.1.2.1.211.1.1.1.1.4

Type

column

Access

readwrite

Status

current

Units

Kbps

Parent

gBondPortConfEntry

Table

gBondPortConfTable

Siblings

9