tr069RouteTosMask
FEC-TR069-MIB ·
.0.6.7.1.1.12
Object
column
r/w
Integer32
This object describes together with tr069RouteTos the
range of the Type of Service field (TOS) in the IP-header
of the IP-datagrams belonging to the set. A TOS value is
considered within the range, when the following equation
is valid:
(tos & tr069RouteTosMask) == (tr069RouteTos & tr069RouteTosMask)
If both objects are set to 0 the TOS value of the datagrams
in the set is not specified and can take any value.
Context
- MIB
- FEC-TR069-MIB
- OID
.0.6.7.1.1.12- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- tr069RouteEntry
- Table
- tr069RouteTable
- Siblings
- 26
Syntax
Integer32
Values & Constraints
Object Constraints
range: 0-255
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| tr069RouteProtocol This object specifies the value of the protocol field in
the ip header for all IP-datagrams belonging to the set.
If this object is set to dont-verify, the value of the
protocol f… | column | Enumeration | .0.6.7.1.1.1 |
| tr069RouteDstPortRange This object describes together with tr069RouteDstPort the
range of target-portnumbers of the IP-datagrams belonging to
the set. All portnumbers between and including the two
objec… | column | Integer32 | .0.6.7.1.1.10 |
| tr069RouteTos This object describes together with tr069RouteTosMask the
range of the Type of Service field (TOS) in the IP-header
of the IP-datagrams belonging to the set. A TOS value is
consid… | column | Integer32 | .0.6.7.1.1.11 |
| tr069RouteDstIfMode This object describes different behavior depending on the
ifOperStatus of the destination interface:
dialup-wait:
The route matches, when the ifOperStatus of the
… | column | Enumeration | .0.6.7.1.1.13 |
| tr069RouteDstIfIndex This object specifies the destination interface for the
IP-datagrams belonging to the set. If the value of this
object is set to 0, the datagrams of the set are discarded
and an I… | column | SNMPv2-SMIInteger32 | .0.6.7.1.1.14 |
| tr069RouteNextHop This object is used on point-to-multipoint interfaces
with indirect routes (see ipExrRtType) to specify
the IP-address of the gateway on the network, where
the datagram should be … | column | SNMPv2-SMIIpAddress | .0.6.7.1.1.15 |
| tr069RouteType This object specifies, on point-to-multipoint interface
whether the datagram shall be sent to the destination
IP address in the IP datagram header (direct) or
to a gateway (indire… | column | Enumeration | .0.6.7.1.1.16 |
| tr069RouteMetric1 This object is used to specify an order on the entries
in the tr069RouteTable. If a datagram is matching multiple
entries, the entry with the lowest value of tr069RouteMetric1
is … | column | SNMPv2-SMIInteger32 | .0.6.7.1.1.17 |
| tr069RouteMetric2 Undefined yet; for further extension | column | SNMPv2-SMIInteger32 | .0.6.7.1.1.18 |
| tr069RouteMetric3 Undefined yet; for further extension | column | SNMPv2-SMIInteger32 | .0.6.7.1.1.19 |
| tr069RouteSrcIfIndex This object specifies the source index of the IP-datagrams.
If this object has a value other than 0, only datagrams
received over the interface with the appropriate interface
ind… | column | SNMPv2-SMIInteger32 | .0.6.7.1.1.2 |
| tr069RouteMetric4 Undefined yet; for further extension | column | SNMPv2-SMIInteger32 | .0.6.7.1.1.20 |
| tr069RouteMetric5 Undefined yet; for further extension | column | SNMPv2-SMIInteger32 | .0.6.7.1.1.21 |
| tr069RouteProto This object describes, how the route has been gained.
This will normaly be netmgmt, because there is currently
no routing protocol, that is able to handle extended routes. | column | Enumeration | .0.6.7.1.1.22 |
| tr069RouteAge This object specifies the age of the route. | column | SNMPv2-SMITimeTicks | .0.6.7.1.1.23 |
| tr069RouteIdx This is the TR-069 index of the route. | column | Integer32 | .0.6.7.1.1.24 |
| tr069RouteState This is the TR-069 enabled state of the route. | column | Enumeration | .0.6.7.1.1.25 |
| tr069RouteOrigin This is the table the route was imported from. | column | Enumeration | .0.6.7.1.1.26 |
| tr069RouteOrigRow This is the row no. of the original entry. | column | Integer32 | .0.6.7.1.1.27 |
| tr069RouteSrcAddr This object describes together with tr069RouteSrcMask the
range of the source-addresses of the IP-datagrams belonging
to the set. If both objects are set to 0.0.0.0 the source-
ad… | column | SNMPv2-SMIIpAddress | .0.6.7.1.1.3 |
| tr069RouteSrcMask This object describes together with tr069RouteSrcAddr the
range of the source-addresses of the IP-datagrams belonging
to the set. If both objects are set to 0.0.0.0 the source-
ad… | column | SNMPv2-SMIIpAddress | .0.6.7.1.1.4 |
| tr069RouteSrcPort This object describes together with tr069RouteSrcPortRange the
range of source portnumbers of the IP-datagrams belonging to
the set. All portnumbers between and including the two
… | column | Integer32 | .0.6.7.1.1.5 |
| tr069RouteSrcPortRange This object describes together with tr069RouteSrcPort the
range of source portnumbers of the IP-datagrams belonging to
the set. All portnumbers between and including the two
objec… | column | Integer32 | .0.6.7.1.1.6 |
| tr069RouteDstAddr This object describes together with tr069RouteDstMask the
range of the target-addresses of the IP-datagrams belonging
to the set. If both objects are set to 0.0.0.0 the target-
ad… | column | SNMPv2-SMIIpAddress | .0.6.7.1.1.7 |
| tr069RouteDstMask This object describes together with tr069RouteDstAddr the
range of the target-addresses of the IP-datagrams belonging
to the set. If both objects are set to 0.0.0.0 the target-
ad… | column | SNMPv2-SMIIpAddress | .0.6.7.1.1.8 |
| tr069RouteDstPort This object describes together with tr069RouteDstPortRange the
range of target-portnumbers of the IP-datagrams belonging to
the set. All portnumbers between and including the two
… | column | Integer32 | .0.6.7.1.1.9 |