agentSnmpServerPortNum

EdgeSwitch-SWITCHING-MIB · .1.3.6.1.4.1.4413.1.1.1.2.6.7

Object

scalar r/w Integer32

Get/Set the UDP port number that the SNMP server listens to for incoming
requests. The port number is an integer value from 1025 to 65535. Before setting
this object, check your system (e.g. using 'netstat') to make sure the desired
port number is not currently being used by any other service. The default
value for this object is 161.

Note that changing the value of this object may cause existing SNMP transactions
to cease communicating with the device until the client applications are
reconfigured to use the new port number.

Context

MIB: EdgeSwitch-SWITCHING-MIB
OID: .1.3.6.1.4.1.4413.1.1.1.2.6.7
Type: scalar
Access: readwrite
Status: current
Parent: agentSnmpConfigGroup
Siblings: 7

Syntax

Integer32

Values & Constraints

No enumerated values or constraints recorded.

Related Objects

Sibling Objects

Object	Type	Syntax	OID
agentSnmpCommunityCreate Creates a new SNMP Community entry. Defaults: IPAddress 0.0.0.0 IpMask 0.0.0.0 AccessMode read-only Status config	scalar	OctetString	`.1.3.6.1.4.1.4413.1.1.1.2.6.1`
agentSnmpCommunityConfigTable A table of the switch's SNMP Config entries	table	-	`.1.3.6.1.4.1.4413.1.1.1.2.6.2`
agentSnmpTrapReceiverCreate Creates a new trap receiver entry. Defaults: IPAddress 0.0.0.0 status config	scalar	OctetString	`.1.3.6.1.4.1.4413.1.1.1.2.6.3`
agentSnmpTrapReceiverConfigTable Trap messages are sent across a network to an SNMP Network Manager. These messages alert the manager to events occurring within the switch or on the network. Up to six simultaneou…	table	-	`.1.3.6.1.4.1.4413.1.1.1.2.6.4`
agentSnmpTrapFlagsConfigGroup	node	-	`.1.3.6.1.4.1.4413.1.1.1.2.6.5`
agentSnmpTrapSourceInterface A source-interface selection on an Interface Index (like vlan based routing interface, port based routing interface, loopback interface, tunnel interface). A non-zero value indi…	scalar	IF-MIBInterfaceIndexOrZero	`.1.3.6.1.4.1.4413.1.1.1.2.6.6`
agentSnmpTrapServicePortSrcInterface To select Service Port as a source-interface.	scalar	Enumeration	`.1.3.6.1.4.1.4413.1.1.1.2.6.8`

Indexes