docsPnmCmtsUsOfdmaRxPwrOnePtSix
DOCS-PNM-MIB ·
.1.3.6.1.4.1.4491.2.1.27.1.3.6.1.5
Object
column
DOCS-IF-MIBTenthdB
This attribute represents the average power of the probe measured by the CMTS, reported as the Power Spectral Density in an equivalent 6.4 MHz spectrum, for the CM whose MAC address was specified in the CmMac attribute. If the NumberOfAverages attribute was greater than one, then this attribute represents the accumulated average 6.4 MHz PSD.
Context
- MIB
- DOCS-PNM-MIB
- OID
.1.3.6.1.4.1.4491.2.1.27.1.3.6.1.5- Type
- column
- Access
- readonly
- Status
- current
- Parent
- docsPnmCmtsUsOfdmaRxPwrEntry
- Table
- docsPnmCmtsUsOfdmaRxPwrTable
- Siblings
- 5
Syntax
DOCS-IF-MIBTenthdB
- Source
- DOCS-IF-MIBTenthdB
- Base type
Integer32
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| docsPnmCmtsUsOfdmaRxPwrEnable This attribute causes the CMTS to begin a measurement of the received
upstream channel power for the CM whose MAC address was specified in
the CmMac attribute.
Inte… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.4491.2.1.27.1.3.6.1.1 |
| docsPnmCmtsUsOfdmaRxPwrCmMac This attribute represents the MAC address of the CM whose Received
upstream channel power is being measured.
This object cannot be changed while a capture is in pro… | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.4491.2.1.27.1.3.6.1.2 |
| docsPnmCmtsUsOfdmaRxPwrPreEq This attribute is used by the CMTS to enable or disable pre-equalization
of the probe. The pre-equalization is controlled by a bit in the Probe
Information Element sent in a MAP t… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.4491.2.1.27.1.3.6.1.3 |
| docsPnmCmtsUsOfdmaRxPwrNumAvgs This attribute controls the time average over the number of probes the
CCAP will use to calculate the docsPnmCmtsUsOfdmaRxPwrOnePtSix. The
average is simply the sum of the docsPnm… | column | Unsigned32 | .1.3.6.1.4.1.4491.2.1.27.1.3.6.1.4 |
| docsPnmCmtsUsOfdmaRxPwrMeasStatus This attribute is used to determine the status of the measurement.
When the Status = SampleReady, the CCAP is ready for the Upstream
Power data to be read. | column | MeasStatusType | .1.3.6.1.4.1.4491.2.1.27.1.3.6.1.6 |