ctIFRemap2Table

Object

table mandatory

This table provides the ability to remap all frames from one
port onto another port.  A port is defined by 
ctIFRemap2PortIndex
from the ctIFRemap2PortTable below.  Only ports listed in the
ctIFRemap2PortTable are available for remapping.
          
A given source port may only be mapped to only one destination 
port.  Once a port is reserved as part of a ctIFRemap2Table  entry,
it may not be used in any other ctIFRemap2Table entries (ie. If 
remapping port 1 to port 3, then neither port 1 or port 3 may be
used as a ctIFRemap2SourcePort or ctIFRemap2DestPort in another
ctIFRemap2Table entry).
          
Each row that exists in this table defines such a relationship.
By disabling a row in this table the remapping relationship no 
longer exists.
          
Each entry will be referenced by slot.  In the case of a
stand-alone device the slot will always be 1.
          
If a given relationship cannot be created the set will fail
with a BAD-VALUE error.

Context

MIB: CTRON-IF-REMAP-2-MIB
OID: .1.3.6.1.4.1.52.4.1.1.14.1.1
Type: table
Status: mandatory
Parent: ctIFRemap2Config
Siblings: 3
Children: 1

Related Objects

Sibling Objects

Object	Type	Syntax	OID
ctIFRemap2PortTable mandatory This table holds all valid ports that are remappable or able to accept a remapped packet.	table	-	`.1.3.6.1.4.1.52.4.1.1.14.1.2`
ctIFRemap2SlotTable mandatory This table contains all information pertaining to the abilities or limitations of a particular remap capable module.	table	-	`.1.3.6.1.4.1.52.4.1.1.14.1.3`
ctIFRemap2VlanTable mandatory This table provides the ability to remap all frames from any port on a particular vlan to a specific destination port. Each row that exists in this table defines such a relation…	table	-	`.1.3.6.1.4.1.52.4.1.1.14.1.4`

Child Objects

Object

Context

Syntax

Values & Constraints

Related Objects