ipTunnelIfAgingTimer
CROUTE-MIB ·
.1.3.6.1.4.1.81.31.8.1.1.14
Object
The timer (minutes) for aging of path MTU discovery. 0 - Disable aging is done.
Context
- MIB
- CROUTE-MIB
- OID
.1.3.6.1.4.1.81.31.8.1.1.14- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- ipTunnelEntry
- Table
- ipTunnelTable
- Siblings
- 17
Syntax
SNMPv2-SMIInteger32
- Source
- SNMPv2-SMIInteger32
- Base type
Integer32
Values & Constraints
Type Constraints
range: -2147483648..2147483647
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| ipTunnelIfIndex A unique value for each interface.
Its value ranges between 1 and the
value of ifNumber. The value for each
interface must remain constant at
least from one re-initialization of
t… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.81.31.8.1.1.1 |
| ipTunnelIfChecksum Verifying checksum of the GRE header.
1 - Check the checksum.
2 - Do not check the checksum.
In case of checksum calaculation does not match to the
packet checksum the packet is … | column | Enumeration | .1.3.6.1.4.1.81.31.8.1.1.10 |
| ipTunnelIfKey The Shared Key for the GRE Tunnel. | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.81.31.8.1.1.11 |
| ipTunnelIfKeyMode The mode according which the Key field is checked or not.
1 - Enable Key
2 - Disable Key | column | Enumeration | .1.3.6.1.4.1.81.31.8.1.1.12 |
| ipTunnelIfOutOfOrderDrop 1 - Drop the packets in case of out of order packets.
2 - Do not Drop the packets in case of out of order packets. | column | Enumeration | .1.3.6.1.4.1.81.31.8.1.1.13 |
| ipTunnelIfMTUDiscovery Path MTU discovery.
1 - Enable Path MTU discovery.
2 - Disable Path MTU discovery. | column | Enumeration | .1.3.6.1.4.1.81.31.8.1.1.15 |
| ipTunnelIfMTU mandatory GRE Tunnel MTU Value (Bytes) | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.81.31.8.1.1.16 |
| ipTunnelIfKeepAliveRetries The number of times that a device will keep sending
keepalive packets without a response before the
interface becomes inactive. This item is changeable only when
ipTunnelIfKeepAl… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.81.31.8.1.1.17 |
| ipTunnelIfKeepAliveRate The rate at which the keepalive packets are sent in
seconds. I.e. One keepalive packet will be send in ipTunnelIfKeepAliveRate seconds.
If ipTunnelIfKeepAliveRate=0 Then Keepalive… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.81.31.8.1.1.18 |
| ipTunnelIfStatus For adding and deleting IP Tunnel
interfaces. Deleting this row means
deleting the corresponding entry in
ifTable (MIB II). | column | RowStatus | .1.3.6.1.4.1.81.31.8.1.1.2 |
| ipTunnelIfLocalAddress The address of the local endpoint of the tunnel,
or 0.0.0.0 if the device is free to choose any
of its addresses at tunnel establishment time. | column | RFC1155-SMIIpAddress | .1.3.6.1.4.1.81.31.8.1.1.3 |
| ipTunnelIfRemoteAddress The address of the remote endpoint of the tunnel. | column | RFC1155-SMIIpAddress | .1.3.6.1.4.1.81.31.8.1.1.4 |
| ipTunnelIfEncapsMethod The encapsulation method used by the tunnel. | column | Enumeration | .1.3.6.1.4.1.81.31.8.1.1.5 |
| ipTunnelIfConfigID An identifier used to distinguish between multiple
tunnels of the same encapsulation method, with the
same endpoints. If the encapsulation protocol only
allows one tunnel per s… | column | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.81.31.8.1.1.6 |
| ipTunnelIfHopLimit The TTL to use in the outer IP header. | column | Integer32 | .1.3.6.1.4.1.81.31.8.1.1.7 |
| ipTunnelIfSecurity The method used by the tunnel to secure the outer IP
header. The value ipsec indicates that IPsec is used
between the tunnel endpoints for authentication or
encryption or both. … | column | Enumeration | .1.3.6.1.4.1.81.31.8.1.1.8 |
| ipTunnelIfDSCP The method used to set the high 6 bits of the
TOS in the outer IP header. A value of -1
indicates that the bits are copied from the payload's
header. A value between 0 and 63 i… | column | Integer32 | .1.3.6.1.4.1.81.31.8.1.1.9 |