firmwareUpdateTarget
CME-MIB ·
.1.3.6.1.4.1.2.3.51.2.22.9.1
Object
scalar
mandatory
r/w
Enumeration
Target module whose firmware will be updated. NOTE: Some switch modules do not allow firmware update. When firmware update is attempted on those switch modules, the agent will report an error.
Context
- MIB
- CME-MIB
- OID
.1.3.6.1.4.1.2.3.51.2.22.9.1- Type
- scalar
- Access
- readwrite
- Status
- mandatory
- Parent
- firmwareUpdate
- Siblings
- 8
Syntax
Enumeration
Values & Constraints
Enumerated Values
0 | managementModule |
11 | switchModule1 |
12 | switchModule2 |
13 | switchModule3 |
14 | switchModule4 |
255 | unknown |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| firmwareUpdateTftpServer mandatory If flashing via the legacy method using a tftp server, then
set the IP address or host name of the TFTP server where
the firmware file resides. The address must be entered in a
do… | scalar | OctetString | .1.3.6.1.4.1.2.3.51.2.22.9.2 |
| firmwareUpdateFileName mandatory File name of the firmware file. | scalar | OctetString | .1.3.6.1.4.1.2.3.51.2.22.9.3 |
| firmwareUpdateStart mandatory Start updating the firmware of the specified target module.
Using execute or execute-with-reboot will cause the SNMP client to
wait for the firmware update to complete.
Using exec… | scalar | Enumeration | .1.3.6.1.4.1.2.3.51.2.22.9.4 |
| firmwareUpdateStatus mandatory Get the status of the last firmware update which was
initiated through SNMP method. | scalar | OctetString | .1.3.6.1.4.1.2.3.51.2.22.9.5 |
| standbyFirmwareUpdateStatus mandatory Get the current status of the firmware update for the standby MM.
NOTE: This only applies to systems with a standby MM. | scalar | OctetString | .1.3.6.1.4.1.2.3.51.2.22.9.6 |
| firmwareImageNumber mandatory If the module can upload more than one image, an image
number must be specified after setting the firmware target.
Please refer to the firmwareInformation section. | scalar | Integer32 | .1.3.6.1.4.1.2.3.51.2.22.9.7 |
| firmwareActiveImage mandatory If the module can upload more than one image, an active image
number must be specified. Please refer to the firmwareInformation section.
NOTE: Value returned for the GET command … | scalar | Integer32 | .1.3.6.1.4.1.2.3.51.2.22.9.8 |
| firmwareUpdateServer mandatory Contains the fully qualified remote location of the firmware
packet file. Use firmwareUpdateFileName to specify the filename.
A fully qualified remote location contains… | scalar | OctetString | .1.3.6.1.4.1.2.3.51.2.22.9.9 |