srpPriorityThreshold
CISCO-SRP-MIB ·
.1.3.6.1.4.1.9.10.60.1.1.1.2
Object
column
r/w
Integer32
The priority threshold value to be compared against
the 3 bits of priority contained in each packet's SRP
header. If a packet's priority is greater or equal to
this threshold, that packet should be placed in the
high priority transmit or transit queue. If a packet's
priority is less than this threshold, it should be
placed in the low priority transmit or transit queue.
Since there are only two types of priority
queues (High Priority and Low Priority) a packet
is treated as either low or high priority once it is
on the ring. Each node determines the threshold
value for classifying what is considered a high
priority packet and what is considered a low priority
packet.
Context
- MIB
- CISCO-SRP-MIB
- OID
.1.3.6.1.4.1.9.10.60.1.1.1.2- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- srpIfEntry
- Table
- srpIfTable
- Siblings
- 7
Syntax
Integer32
Values & Constraints
Object Constraints
range: 0-7
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| srpMACAddress The MAC's 48-bit individual MAC address. | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.9.10.60.1.1.1.1 |
| srpNodesOnTheRing The number of nodes in the SRP ring.
When interface is down the value is 0. | column | Integer32 | .1.3.6.1.4.1.9.10.60.1.1.1.3 |
| srpIpsState Each node in the Intelligent Protection Switching (IPS)
is one of the following states.
Idle - In this mode the node is ready to perform protection
and it sends to both neighborin… | column | Enumeration | .1.3.6.1.4.1.9.10.60.1.1.1.4 |
| srpIpsLockedOut The boolean flag to indicate node
LockedOut of protection state. If it's true than
Intelligent Protection Swiching is disabled and
the node will not wrap on either side of the int… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.10.60.1.1.1.5 |
| srpIpsWaitToRestoreTimer Indicates the length of time in seconds,
to remain in the wrap state, after the cause
of a wrap is removed. This mechanism prevents
protection switch oscillations. Default value i… | column | seconds Integer32 | .1.3.6.1.4.1.9.10.60.1.1.1.6 |
| srpIfTimeElapsed The number of seconds, including partial seconds,
that have elapsed since the beginning of the current
measurement interval as described in RFC 2493.
If, for some reason, such as … | column | seconds Integer32 | .1.3.6.1.4.1.9.10.60.1.1.1.7 |
| srpIfValidIntervals The number of previous 15-minute
measurement intervals
for which data was collected.
A SRP interface must be capable
of supporting at least n intervals.
The minimum value of n is … | column | Integer32 | .1.3.6.1.4.1.9.10.60.1.1.1.8 |