srpIpsWaitToRestoreTimer
CISCO-SRP-MIB ·
.1.3.6.1.4.1.9.10.60.1.1.1.6
Object
column
r/w
seconds Integer32
Indicates the length of time in seconds, to remain in the wrap state, after the cause of a wrap is removed. This mechanism prevents protection switch oscillations. Default value is 60 sec.
Context
- MIB
- CISCO-SRP-MIB
- OID
.1.3.6.1.4.1.9.10.60.1.1.1.6- Type
- column
- Access
- readwrite
- Status
- current
- Units
- seconds
- Parent
- srpIfEntry
- Table
- srpIfTable
- Siblings
- 7
Syntax
seconds Integer32
Values & Constraints
Object Constraints
range: 10-600
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| srpMACAddress The MAC's 48-bit individual MAC address. | column | SNMPv2-TCMacAddress | .1.3.6.1.4.1.9.10.60.1.1.1.1 |
| srpPriorityThreshold The priority threshold value to be compared against
the 3 bits of priority contained in each packet's SRP
header. If a packet's priority is greater or equal to
this threshold, tha… | column | Integer32 | .1.3.6.1.4.1.9.10.60.1.1.1.2 |
| srpNodesOnTheRing The number of nodes in the SRP ring.
When interface is down the value is 0. | column | Integer32 | .1.3.6.1.4.1.9.10.60.1.1.1.3 |
| srpIpsState Each node in the Intelligent Protection Switching (IPS)
is one of the following states.
Idle - In this mode the node is ready to perform protection
and it sends to both neighborin… | column | Enumeration | .1.3.6.1.4.1.9.10.60.1.1.1.4 |
| srpIpsLockedOut The boolean flag to indicate node
LockedOut of protection state. If it's true than
Intelligent Protection Swiching is disabled and
the node will not wrap on either side of the int… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.10.60.1.1.1.5 |
| srpIfTimeElapsed The number of seconds, including partial seconds,
that have elapsed since the beginning of the current
measurement interval as described in RFC 2493.
If, for some reason, such as … | column | seconds Integer32 | .1.3.6.1.4.1.9.10.60.1.1.1.7 |
| srpIfValidIntervals The number of previous 15-minute
measurement intervals
for which data was collected.
A SRP interface must be capable
of supporting at least n intervals.
The minimum value of n is … | column | Integer32 | .1.3.6.1.4.1.9.10.60.1.1.1.8 |