cLRogueApState

This objects specifies the state in which
the rogue AP is.
              
pending          - a read-only value indicates that rogue AP
                   can not be state to any of the following
                   type.
alert            - rogue AP can be a potential threat.
                   Trap will be sent out to trap recipients.
detectedLrad     - a read-only value indicates that a LRAD
                   that got detected as rogue.
known            - a read-only value indicates that an internal
                   AP which is not on the same switch.
acknowledge      - a read-only value indicates that an external
                   AP whose existence is acceptable and not a
                   threat(probably from vendor other than
                   cisco).
contained        - containment is initiated and ongoing.
threat           - rogue AP is found on wired network.
containedPending - a read-only value indicates that no AP
                   resources available for containment.
knownContained   - a read-only value indicates that no longer
                   used.
trustedMissing   - rogue AP is friendly but there is no slot
                   for friendly AP.
initializing     - a read-only value indicates that rogue
                   AP is being initialized.
              
For a friendly rogue AP, only two states are valid:
'known' and 'acknowledge'.
              
'known', 'knownContained' and 'trustedMissing'
can appear in known rogue list.
              
Known rogues can be pre-provisioned and known rogues
state can be changed to 'alert'.

MIB

CISCO-LWAPP-ROGUE-MIB

OID

.1.3.6.1.4.1.9.9.610.1.1.6.1.1.3

Type

column

Access

readwrite

Status

deprecated

Parent

cLRogueApEntry