citapStreamCapabilities – CISCO-IP-TAP-MIB

Object

scalar Bits

This object displays what types of intercept streams can be
configured on this type of device. This may be dependent on
hardware capabilities, software capabilities. The following
fields may be supported:
    tapEnable:   set if table entries with
                 cTap2StreamInterceptEnable set to 'false'
                 are used to pre-screen packets for intercept;
                 otherwise these entries are ignored.
    interface:   SNMP ifIndex Value may be used to select
                 interception of all data crossing an
                 interface or set of interfaces.
    ipV4:        IPv4 Address or prefix may be used to select
                 traffic to be intercepted.
    ipV6:        IPv6 Address or prefix may be used to select
                 traffic to be intercepted.
    l4Port:      TCP/UDP Ports may be used to select traffic
                 to be intercepted.
    dscp:        DSCP (Differentiated Services Code Point) may
                 be used to select traffic to be intercepted.
    voip:        packets belonging to a voice session may
                 be intercepted using source IPv4 address and
                 source UDP port.

Context

MIB: CISCO-IP-TAP-MIB
OID: .1.3.6.1.4.1.9.9.394.1.1.1
Type: scalar
Access: readonly
Status: current
Parent: citapStreamEncodePacket
Siblings: 1

Syntax

Bits

Values & Constraints

Enumerated Values

`0`	tapEnable
`1`	interface
`2`	ipV4
`3`	ipV6
`4`	l4Port
`5`	dscp
`6`	voip

Related Objects

Sibling Objects

Object	Type	Syntax	OID
citapStreamTable The Intercept Stream IP Table lists the IPv4 and IPv6 streams to be intercepted. The same data stream may be required by multiple taps, and one might assume that often the interc…	table	-	`.1.3.6.1.4.1.9.9.394.1.1.2`