cErrDisableFeatureRecoveryInterval
CISCO-ERR-DISABLE-MIB ·
.1.3.6.1.4.1.9.9.548.1.2.1.1.5
Object
This object specifies the error-recovery time interval
that will be used by the system for any system entity that
is error-disabled by this particular feature.
If the value of this object is '0', then the device will
use the value specified by the global configuration object
cErrDisableRecoveryInterval.
Context
- MIB
- CISCO-ERR-DISABLE-MIB
- OID
.1.3.6.1.4.1.9.9.548.1.2.1.1.5- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cErrDisableFeatureEntry
- Table
- cErrDisableFeatureTable
- Siblings
- 7
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cErrDisableFeatureIndex This object uniquely identifies a feature that makes
use of the error-disable feature. | column | CErrDisableFeatureID | .1.3.6.1.4.1.9.9.548.1.2.1.1.1 |
| cErrDisableFeatureConfigurable This object indicates whether the error-disable related
configuration is configurable for this feature. If a bit
is set to 1, then the corresponding error-disable
configuration ca… | column | Bits | .1.3.6.1.4.1.9.9.548.1.2.1.1.2 |
| cErrDisableFeatureDetectEnable This object specifies whether the error-disable detection
is enabled for the feature.
Note:
This object is read-write only for those features
that are configu… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.548.1.2.1.1.3 |
| cErrDisableFeatureRecoveryEnable This object specifies whether the system can
automatically recover a system entity that has been
disabled by the feature. | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.548.1.2.1.1.4 |
| cErrDisableFeatureDetectShutdownVlan This object specifies whether shutting down the violating
VLAN on an interface is enabled or not. The value of 'true'
indicates that shutting down the violating VLAN on an
interf… | column | SNMPv2-TCTruthValue | .1.3.6.1.4.1.9.9.548.1.2.1.1.6 |
| cErrDisableFeatureMaxFlapCount This object specifies the maximum number of flaps that
are allowed to occur before setting to error disable state.
A read-only value of zero indicates that no flap control
is pres… | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.548.1.2.1.1.7 |
| cErrDisableFeatureFlapTimePeriod This object specifies the period of time counting the number of
flaps that are allowed before setting to error disable state.
A read-only value of zero indicates that no flap cont… | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.9.9.548.1.2.1.1.8 |