cdot3OamMode
CISCO-DOT3-OAM-MIB ·
.1.3.6.1.4.1.9.10.136.1.1.1.3
Object
column
r/w
Enumeration
This object configures the mode of OAM operation for this
Ethernet like interface. OAM on Ethernet interfaces may be in
'active' mode or 'passive' mode. These two modes differ in
that active mode provides additional capabilities to initiate
monitoring activities with the remote OAM peer entity, while
passive mode generally waits for the peer to initiate OAM
actions with it. As an example, an active OAM entity can put
the remote OAM entity in a loopback state, where a passive OAM
entity cannot.
The default value of cdot3OamMode is dependent on the type of
system on which this Ethernet like interface resides. The
default value should be 'active(1)' unless it is known that
this system should take on a subservient role to the other
device connected over this interface.
Changing this value results in incrementing the configuration
revision field of locally generated OAMPDUs (30.3.6.1.12) and
potentially re-doing the OAM discovery process if the
cdot3OamOperStatus was already operational(9).
Context
- MIB
- CISCO-DOT3-OAM-MIB
- OID
.1.3.6.1.4.1.9.10.136.1.1.1.3- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- cdot3OamEntry
- Table
- cdot3OamTable
- Siblings
- 5
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | active |
2 | passive |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cdot3OamAdminState This object is used to provision the default administrative
OAM mode for this interface. This object represents the
desired state of OAM for this interface.
The … | column | Enumeration | .1.3.6.1.4.1.9.10.136.1.1.1.1 |
| cdot3OamOperStatus At initialization and failure conditions, two OAM entities on
the same full-duplex Ethernet link begin a discovery phase to
determine what OAM capabilities may be used on that lin… | column | Enumeration | .1.3.6.1.4.1.9.10.136.1.1.1.2 |
| cdot3OamMaxOamPduSize The largest OAMPDU that the OAM entity supports. OAM
entities exchange maximum OAMPDU sizes and negotiate to use
the smaller of the two maximum OAMPDU sizes between the peers.
Th… | column | octets Unsigned32 | .1.3.6.1.4.1.9.10.136.1.1.1.4 |
| cdot3OamConfigRevision The configuration revision of the OAM entity as reflected in
the latest OAMPDU sent by the OAM entity. The config revision
is used by OAM entities to indicate configuration chang… | column | Unsigned32 | .1.3.6.1.4.1.9.10.136.1.1.1.5 |
| cdot3OamFunctionsSupported The OAM functions supported on this Ethernet like interface.
OAM consists of separate functional sets beyond the basic
discovery process which is always required. These functiona… | column | Bits | .1.3.6.1.4.1.9.10.136.1.1.1.6 |