cat2600TsTrapRcvrTable
CAT2600-MIB ·
.1.3.6.1.4.1.9.1.111.1.2.1.1.14
Object
table
mandatory
A table of managers to which to send traps. Entries in the table are saved across resets and power cycles.
Context
- MIB
- CAT2600-MIB
- OID
.1.3.6.1.4.1.9.1.111.1.2.1.1.14- Type
- table
- Status
- mandatory
- Parent
- cat2600TsConfig
- Siblings
- 19
- Children
- 1
Syntax
No syntax metadata recorded.
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cat2600TsFwVer mandatory The firmware version in the form major.minor. For
port microcode (SOLO) version information see the
mgmt.mib-2.interfaces.ifTable.ifEntry.ifDescr object. | scalar | OctetString | .1.3.6.1.4.1.9.1.111.1.2.1.1.1 |
| cat2600TsDefaultGateway mandatory IP default gateway used by the switch. Changes to this
object take effect immediately. | scalar | RFC1155-SMIIpAddress | .1.3.6.1.4.1.9.1.111.1.2.1.1.10 |
| cat2600TsPingInterval mandatory This variable specifies the interval in seconds of
sending ICMP Echo Requests to the default gateway.
No PING packets will be sent if the value is set to 0.
The default interval i… | scalar | Integer32 | .1.3.6.1.4.1.9.1.111.1.2.1.1.19 |
| cat2600TsHwVer mandatory The hardware version in the form major.minor. | scalar | OctetString | .1.3.6.1.4.1.9.1.111.1.2.1.1.2 |
| cat2600TsTapPort mandatory Select the port to monitor traffic. | scalar | Integer32 | .1.3.6.1.4.1.9.1.111.1.2.1.1.20 |
| cat2600TsTapMonitoredPort mandatory Allows the selection of the port that will be monitored by the
port selected by cat2600TsTapPort. | scalar | Integer32 | .1.3.6.1.4.1.9.1.111.1.2.1.1.21 |
| cat2600TsCrcThresholdHi mandatory Threshold for the switch to change to store and
forward mode. A change in mode also generates a trap. | scalar | Integer32 | .1.3.6.1.4.1.9.1.111.1.2.1.1.22 |
| cat2600TsCrcThresholdLow mandatory Threshold for the switch to change to store and
forward mode. A change in mode also generates a trap. | scalar | Integer32 | .1.3.6.1.4.1.9.1.111.1.2.1.1.23 |
| cat2600TsPortSwitchModeChangeTrapEnable mandatory Enable or disable the trap sent out when the switching
mode changes from cut-through to store and forward. | scalar | Enumeration | .1.3.6.1.4.1.9.1.111.1.2.1.1.24 |
| cat2600TsTrendThreshold mandatory Based on trend calculation of the Dynamic Cut State
algorithm, when this value is exceeded the port
changes from cut-through to store and forward mode.
The default value for this … | scalar | Integer32 | .1.3.6.1.4.1.9.1.111.1.2.1.1.25 |
| cat2600TsSamplingPeriod mandatory Sampling period in minutes for determining if the
error rate of CRC errors has been exceeded.
The default value for this object is 10 minutes. The
valid range is 1-120. | scalar | Integer32 | .1.3.6.1.4.1.9.1.111.1.2.1.1.26 |
| cat2600TsNumberUFC mandatory The number of UFCs installed in the switch. A value
of zero (or an SNMP error of NOSUCH) indicates there are
NO UFCs installed in this switch.
This value indicates the number of … | scalar | Integer32 | .1.3.6.1.4.1.9.1.111.1.2.1.1.27 |
| cat2600TsSerialNumber mandatory System serial number. | scalar | OctetString | .1.3.6.1.4.1.9.1.111.1.2.1.1.3 |
| cat2600TsInstallationDate mandatory Firmware installation date. This date is initially
set by the Network Management station. Each time
the NV RAM is cleared through the console this date
needs to be set by the mana… | scalar | OctetString | .1.3.6.1.4.1.9.1.111.1.2.1.1.4 |
| cat2600TsFwSize mandatory Size in bytes of the binary firmware image. | scalar | Integer32 | .1.3.6.1.4.1.9.1.111.1.2.1.1.5 |
| cat2600TsFwCRC mandatory Firmware binary image CRC value. | scalar | Integer32 | .1.3.6.1.4.1.9.1.111.1.2.1.1.6 |
| cat2600TsFwManufacturer mandatory Firmware manufacturer. | scalar | OctetString | .1.3.6.1.4.1.9.1.111.1.2.1.1.7 |
| cat2600TsIpAddr mandatory IP address of the switch. Changes to this object
take effect immediately. | scalar | RFC1155-SMIIpAddress | .1.3.6.1.4.1.9.1.111.1.2.1.1.8 |
| cat2600TsNetMask mandatory IP subnet mask of the switch. Changes to this object
take effect immediately. | scalar | RFC1155-SMIIpAddress | .1.3.6.1.4.1.9.1.111.1.2.1.1.9 |
Child Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| cat2600TsTrapRcvrEntry mandatory Definition of rows in the trap receiver table.
The column cat2600TsTrapRcvrStatus is used to create
and delete rows in the table. Creation requires
a SET PDU with objects cat2600… | row | - | .1.3.6.1.4.1.9.1.111.1.2.1.1.14.1 |