cat2600TsNumResets

CAT2600-MIB · .1.3.6.1.4.1.9.1.111.1.2.1.2.6
MIB view Table view

Object

scalar mandatory RFC1155-SMICounter 
Number of soft resets the switch has executed
since the last hard reset or power cycle.  Soft
resets are defined as writing softReset(3) to
cat2600TsReset, pressing the front panel reset button,
executing a soft reset from the console, or resets
induced by the switch firmware.

Context

MIB
CAT2600-MIB
OID
.1.3.6.1.4.1.9.1.111.1.2.1.2.6
Type
scalar
Access
readonly
Status
mandatory
Parent
cat2600TsSys
Siblings
9

Syntax

RFC1155-SMICounter
Source
RFC1155-SMICounter
Base type
Unsigned32

Values & Constraints

Type Constraints
range: 0..4294967295

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
cat2600TsNumPorts mandatory
The maximum number of physical ports on the switch. This value includes all base ports plus all ports on any UFC cards. It does not include internally defined Bridge Relay Functi…
scalarInteger32.1.3.6.1.4.1.9.1.111.1.2.1.2.1
cat2600TsSysTemperature mandatory
Temperature condition of the system. A change in this value generates a TRAP.
scalarEnumeration.1.3.6.1.4.1.9.1.111.1.2.1.2.11
cat2600TsInstalledMemory mandatory
Total amount of CPU memory installed (in megabytes).
scalarInteger32.1.3.6.1.4.1.9.1.111.1.2.1.2.12
cat2600TsSysCurTime mandatory
Current time at the switch. To set the time use the format yyyy mm dd hh mm ss. All fields are required.
scalarOctetString.1.3.6.1.4.1.9.1.111.1.2.1.2.13
cat2600TsNumStations mandatory
Aggregate number of currently active stations (nodes) on all ports on the switch.
scalarInteger32.1.3.6.1.4.1.9.1.111.1.2.1.2.2
cat2600TsMostStations mandatory
Highest aggregate number of stations ever active on all ports at one time, since the last reset or power cycle. This includes the default MAC address entries from each port.
scalarInteger32.1.3.6.1.4.1.9.1.111.1.2.1.2.3
cat2600TsMaxStations mandatory
Highest aggregate number of stations which the switch can support simultaneously.
scalarInteger32.1.3.6.1.4.1.9.1.111.1.2.1.2.4
cat2600TsReset mandatory
This object is used to reset the switch. Writing softReset(3) causes the switch to reset the hardware, run quick diagnostics, clear all counters, start switching, issue a warmsta…
scalarEnumeration.1.3.6.1.4.1.9.1.111.1.2.1.2.5
cat2600TsAddrAgingTime mandatory
Number of minutes of inactivity before an address entity is aged out. A value of zero means no aging. Note: if an address shows up on another port, the original port to addres…
scalarInteger32.1.3.6.1.4.1.9.1.111.1.2.1.2.7