rxColorCode
CAMBIUM-PTP600-MIB ·
.1.3.6.1.4.1.17713.6.10.6
Object
scalar
Enumeration
Receive Color Code. This attribute need only be considered when the unit is installed in a network of PTP600 units and where some of the units are operating on the same frequency. In this case, the value would normally be derived by a network planner. In all other cases, it is recommended that this attribute is left at the default value. NOTE: For the link to operate, the value of this parameter must in all cases match the value of the Tx Color Code parameter at the far end of the link.
Context
- MIB
- CAMBIUM-PTP600-MIB
- OID
.1.3.6.1.4.1.17713.6.10.6- Type
- scalar
- Access
- readonly
- Status
- current
- Parent
- phyControl
- Siblings
- 7
Syntax
Enumeration
Values & Constraints
Enumerated Values
0 | a |
1 | b |
2 | c |
3 | d |
4 | e |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| linkSymmetry Link Symmetry: in fixed symmetric mode the master spends
an equal amount of time transmitting and receiving; in
fixed asymmetric modes the master transmit and receive
times hav… | scalar | Enumeration | .1.3.6.1.4.1.17713.6.10.1 |
| linkModeOptimisation Optimises the wireless link behavior for the type of
traffic to be carried. In 'IP Traffic' mode, the wireless
link will minimise transmission errors by automatically
adapting … | scalar | Enumeration | .1.3.6.1.4.1.17713.6.10.2 |
| userConfiguredMaxModulationMode The maximum receive modulation mode controls the MAX
mode used for adaptive modulation. NOTE: This attribute
is automatically disabled when the installation agent is
armed. To … | scalar | Enumeration | .1.3.6.1.4.1.17713.6.10.3 |
| remoteMaximumTransmitPower Maximum transmit power the remote wireless unit is
permitted to use when establishing and maintaining the
wireless link | scalar | Integer32 | .1.3.6.1.4.1.17713.6.10.4 |
| txColorCode Transmit Color Code. This attribute need only be
considered when the unit is installed in a network of
PTP600 units and where some of the units are operating on
the same freque… | scalar | Enumeration | .1.3.6.1.4.1.17713.6.10.5 |
| automaticTxPowerControl When enabled, the transmit power of the local end is
automatically adjusted to maintain a configurable target
receive signal level at the remote end of the link. When
set to En… | scalar | Enumeration | .1.3.6.1.4.1.17713.6.10.8 |
| remoteRxTargetPower This is the target receive level for the end of the link
which is remote from the end being configured. When
Automatic Power Control is enabled, the transmit power of
the local… | scalar | Integer32 | .1.3.6.1.4.1.17713.6.10.9 |