incompatibleMasterAndSlave
CAMBIUM-PTP600-MIB ·
.1.3.6.1.4.1.17713.6.13.10
Object
scalar
Enumeration
A non-zero value indicates that the master and slave ends of a link are different hardware products, or have different software versions. NB: It is very unusual to detect this, because incompatible units will normally fail to establish a wireless link. However, some combinations may establish a partial wireless link and detect this situation. NB: A non-zero value may generate an SNMP trap and/or SMTP email alert
Context
- MIB
- CAMBIUM-PTP600-MIB
- OID
.1.3.6.1.4.1.17713.6.13.10- Type
- scalar
- Access
- readonly
- Status
- current
- Parent
- alarms
- Siblings
- 14
Syntax
Enumeration
Values & Constraints
Enumerated Values
0 | ok |
1 | incompatibleProductVariants |
2 | differentSoftwareVersionsRunning |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| unitOutOfCalibration The unit is out of calibration | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.1 |
| tDDSynchronizationStatus An alarm value (displayed in red) indicates that one of
the following conditions has not been met (i) An external
timing system is connected or internal timing has been
configu… | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.11 |
| managementPortDisabledWarning The SNMP ifAdminStatus of the out-of-band management
interface has disabled Ethernet traffic | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.12 |
| tDDSynchronizationAlarm Not Synchronized indicates failure of the external
timing system for a period greater than the holdover
timer. TDD frame timing will have drifted, and this link
may cause inter… | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.13 |
| linkModeOptimizationMismatch The remote node of this link has been configured with a
different link mode optimization | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.14 |
| managementPortConfigurationMismatch The detection of Ethernet fragments (runt packets) when
the link is in full duplex is an indication of an
auto-negotiation or forced configuration mismatch. This
alarm is only … | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.15 |
| secureModeAlarm The secure mode (e.g. FIPS, UC-APL) state of the unit.
The secure mode is not configured(1) state indicates that
the unit is capable of secure mode operation, and one or
more o… | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.16 |
| ethernetBridgingStatusAlarm Ethernet traffic bridging is disabled because the
wireless link is not operating at the configured Lowest
Ethernet Modulation Mode | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.17 |
| incompatibleRegionCodes The master and slave units have incompatible region
codes. NB: Both units must have compatible license keys | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.4 |
| noWirelessChannelAvailable Spectrum Management was unable to locate a suitable
wireless channel to operate on | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.5 |
| wirelessLinkDisabledWarning The SNMP ifAdminStatus of the wireless interface has
disabled wireless traffic | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.6 |
| dataPortDisabledWarning The SNMP ifAdminStatus of the Ethernet interface has
disabled Ethernet traffic | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.7 |
| dataPortFiberStatus If the fiber link is not OK, there are three possible
causes: Either the fiber link has been installed but
disabled (because the license key does not include fiber
support), th… | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.8 |
| dataPortConfigurationMismatch The detection of Ethernet fragments (runt packets) when
the link is in full duplex is an indication of an
auto-negotiation or forced configuration mismatch | scalar | Enumeration | .1.3.6.1.4.1.17713.6.13.9 |