firmwareImageNumber

BLADE-MIB · .1.3.6.1.4.1.2.3.51.2.22.9.7
MIB view Table view

Object

scalar mandatory r/w Integer32 
If the module can upload more than one image, an image
number must be specified after setting the firmware target.
Please refer to the firmwareInformation section.

Context

MIB
BLADE-MIB
OID
.1.3.6.1.4.1.2.3.51.2.22.9.7
Type
scalar
Access
readwrite
Status
mandatory
Parent
firmwareUpdate
Siblings
8

Syntax

Integer32
Source
COPS-PR-SPPIInteger32
Base type
Integer32

Values & Constraints

Type Constraints
range: -2147483648..2147483647

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
firmwareUpdateTarget mandatory
Target module whose firmware will be updated. NOTE: Some switch modules do not allow firmware update. When firmware update is attempted on those switch modules, the agent will rep…
scalarEnumeration.1.3.6.1.4.1.2.3.51.2.22.9.1
firmwareUpdateTftpServer mandatory
If flashing via the legacy method using a tftp server, then set the IP address or host name of the TFTP server where the firmware file resides. The address must be entered in a do…
scalarOctetString.1.3.6.1.4.1.2.3.51.2.22.9.2
firmwareUpdateFileName mandatory
File name of the firmware file.
scalarOctetString.1.3.6.1.4.1.2.3.51.2.22.9.3
firmwareUpdateStart mandatory
Start updating the firmware of the specified target module. Using execute or execute-with-reboot will cause the SNMP client to wait for the firmware update to complete. Using exec…
scalarEnumeration.1.3.6.1.4.1.2.3.51.2.22.9.4
firmwareUpdateStatus mandatory
Get the status of the last firmware update which was initiated through SNMP method.
scalarOctetString.1.3.6.1.4.1.2.3.51.2.22.9.5
standbyFirmwareUpdateStatus mandatory
Get the current status of the firmware update for the standby AMM. NOTE: This only applies to systems with a standby AMM.
scalarOctetString.1.3.6.1.4.1.2.3.51.2.22.9.6
firmwareActiveImage mandatory
If the module can upload more than one image, an active image number must be specified. Please refer to the firmwareInformation section. NOTE: Value returned for the GET command …
scalarInteger32.1.3.6.1.4.1.2.3.51.2.22.9.8
firmwareUpdateServer mandatory
Contains the fully qualified remote location of the firmware packet file. Use firmwareUpdateFileName to specify the filename. A fully qualified remote location contains…
scalarOctetString.1.3.6.1.4.1.2.3.51.2.22.9.9