ipNatPrOperExtPort
BINTEC-IPEXT-MIB ·
.0.63.1.7
Object
column
Integer32
This object specifies together with ipNatPrOperExtPortRange the range of portnumbers for incoming packets, for which the table entry shall be valid. If both objects are set to -1, the entry is valid for all portnumbers. If ipNatPrOperPortRange is set to -1, the entry is only valid, when the destination portnumber of an incoming packet is equal to ipNatPrOperExtPort. Otherwise, the entry is valid, if the destination portnumber lies in the range ExtPort .. ExtPortRange.
Context
- MIB
- BINTEC-IPEXT-MIB
- OID
.0.63.1.7- Type
- column
- Access
- readonly
- Status
- current
- Parent
- ipNatPresetOperEntry
- Table
- ipNatPresetOperTable
- Siblings
- 14
Syntax
Integer32
Values & Constraints
Object Constraints
range: -1-65535
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| ipNatPrOperIfIndex This object specifies the interface index, for which the
table entry shall be valid. If set to 0, the entry will
be valid for all interfaces configured to use NAT. | column | Integer32 | .0.63.1.1 |
| ipNatPrOperIntPort This object specifies the internal target host's port-number
for incoming packets matching the table entry. If this
object is set to -1, the target portnumber will be
taken from t… | column | Integer32 | .0.63.1.10 |
| ipNatPrOperIntMask With ipNatPrOperIntAddr, this object specifies the internal
target host's IP address for incoming packets matching the
table entry.
An incoming packet matching thi… | column | RFC1155-SMIIpAddress | .0.63.1.11 |
| ipNatPrOperTimeout When there is no traffic associated with a NAT entry, this
entry is discarded at the end of a timeout value. This object
holds this timeout value in seconds. If set to the defau… | column | seconds Integer32 | .0.63.1.12 |
| ipNatPrOperTcpOption Additional selector, increases the prossible granularity of
the TCP-related NAT preset rules. This parameter doesn't
matter if not set, in all other cases initial TCP SYN
messages… | column | Bits | .0.63.1.13 |
| ipNatPrOperType Specifies whether there is an associated ipNatPrestTable
entry (permanent) or not (temporary). Note that entries
with type permanent (1) cannot be deleted by the
administrator di… | column | Enumeration | .0.63.1.14 |
| ipNatPrOperParent Row number of the associated ipNatPresetTable entry. | column | Integer32 | .0.63.1.15 |
| ipNatPrOperProtocol This object specifies the protocol, for which the table
entry shall be valid. | column | Enumeration | .0.63.1.2 |
| ipNatPrOperRemoteAddr This object specifies together with ipNatPrOperRemoteMask the
the set of IP addresses of remote hosts initiating a
session. The table entry will be valid for an incoming
packet, w… | column | RFC1155-SMIIpAddress | .0.63.1.3 |
| ipNatPrOperRemoteMask This object specifies together with ipNatPrOperRemoteAddr
the set of IP addresses of remote hosts initiating the
session. The table entry will be valid for an incoming
packet, whe… | column | RFC1155-SMIIpAddress | .0.63.1.4 |
| ipNatPrOperExtAddr This object specifies together with ipNatPrOperExtMask the
set of destination IP addresses, for which the table entry
shall be valid. The entry is valid, if the target IP address
… | column | RFC1155-SMIIpAddress | .0.63.1.5 |
| ipNatPrOperExtMask This object specifies together with ipNatPrOperExtAddr the
set of destination IP addresses, for which the table entry
shall be valid. The entry is valid, if the target IP address
… | column | RFC1155-SMIIpAddress | .0.63.1.6 |
| ipNatPrOperExtPortRange This object specifies together with ipNatPrOperExtPort the
range of portnumbers for incoming packets, for which the table
entry shall be valid. If both objects are set to -1, the
… | column | Integer32 | .0.63.1.8 |
| ipNatPrOperIntAddr With ipNatPrOperIntMask, this object specifies the internal
target host's IP address for incoming packets matching the table
entry.
An incoming packet matching thi… | column | RFC1155-SMIIpAddress | .0.63.1.9 |