ipExtIfNatRmvFin
BINTEC-IPEXT-MIB ·
.0.3.1.7
Object
column
r/w
Enumeration
This object specifies, whether entries in the IpNatTable shall be removed, when TCP-FINS have been received and acknowledged in both directions, a TCP-RST has been received or a ICMP-ERROR message has been received for the entry.
Context
- MIB
- BINTEC-IPEXT-MIB
- OID
.0.3.1.7- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- ipExtIfEntry
- Table
- ipExtIfTable
- Siblings
- 37
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | forwardNoFrames |
2 | forwardAllFramesAsTagged |
3 | forwardAllFramesAsUntagged |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| ipExtIfIndex Unique interface index | column | Integer32 | .0.3.1.1 |
| ipExtIfNatOutXlat This object can be used to switch the outgoing address
translation off. Then, all addresses are passed instead
of being translated. The session mechanism remains
active and implem… | column | Enumeration | .0.3.1.10 |
| ipExtIfAccounting Switch for accounting on the specified interface. An IP
packet is being accounted, when this object is set to
on for either the source or the destination interface. | column | Enumeration | .0.3.1.11 |
| ipExtIfTcpSpoofing Switch for TCP spoofing on this interface. TCP keepalive
polls are answered by the BRICK to prevent unnecessary
ISDN connections. Set this object to on for ISDN
dialup interfaces. | column | Enumeration | .0.3.1.12 |
| ipExtIfAccessAction This object describes the action, that is done,
when a packet received from the interface has been
filtered out. When set to ignore, no action takes
place. When set to refuse, an … | column | Enumeration | .0.3.1.13 |
| ipExtIfAccessReport This object specifies, how a packed filtered by accesslists
should be logged. When set to none, no logging takes place.
When set to info, protocol, ip-addresses and portnumbers
ar… | column | Enumeration | .0.3.1.14 |
| ipExtIfOspf Configure the OSPF status of this interface. Routing
information about routes on passive and active interfaces is
propagated on active interfaces. Only active interfaces run
the… | column | Enumeration | .0.3.1.15 |
| ipExtIfOspfMetric Configure the metric calculation of OSPF interfaces. If set
to auto the metric is calculated based on ifSpeed. If set
to fixed the metric is taken from the ospfIfMetricTable.
Addi… | column | Enumeration | .0.3.1.16 |
| ipExtIfTcpCksum Enable or disable the TCP checksum check for local packets
received on the corresponding interface. Disabling the check
may improve performance for some local applications (i.e.
r… | column | Enumeration | .0.3.1.17 |
| ipExtIfBackRtVerify This object activates an additional check for incoming
packets. If set to on, incoming packets are only accepted
if return packets sent back to their source IP address
would be s… | column | Enumeration | .0.3.1.18 |
| ipExtIfRuleIndex This object defines the index of the first access rule
that is applied for incoming packets. If set to 0 or if
there is no access rule with this index no access rules
are appl… | column | Integer32 | .0.3.1.19 |
| ipExtIfAuthentication This object defines the authentication scheme used for
incoming packets. | column | Enumeration | .0.3.1.20 |
| ipExtIfAuthMode This object defines the authentication mode. If set to strict
each source IP address must be authenticated. If set to
loose all source IP addresses are allowed if at least one
IP… | column | Enumeration | .0.3.1.21 |
| ipExtIfAuthLifeTime This object defines the time in seconds a successful
authentication is valid since the IP partner was
authenticated. | column | seconds Integer32 | .0.3.1.22 |
| ipExtIfAuthKeepalive This object defines the period between short authentications
that are invisible to the user | column | seconds Integer32 | .0.3.1.23 |
| ipExtIfRouteAnnounce This object defines the condition when routes on this
interface are propagated by routing protocols.
If set to up-only routes are only propagated
if the operational status of the … | column | Enumeration | .0.3.1.24 |
| ipExtIfIpFragmentation This object defines different modes used for fragmentation
of IP datagrams greater than the MTU of the destination
interface. If set to enabled (1) each IP datagram will be
splitt… | column | Enumeration | .0.3.1.25 |
| ipExtIfRerouting This object enables or disables rerouting on this interface.
The default value is enabled. If set to disabled, then only
the better one route from two or more possible routes is … | column | Enumeration | .0.3.1.26 |
| ipExtIfBodRuleIndex This object defines the index of the first rule used for
Bandwidth on Demand (BOD) that is applied for incoming and/or
outgoing traffic. If set to 0 or if there is no entry in
the… | column | Integer32 | .0.3.1.27 |
| ipExtIfQosRuleIndex This object defines the index of the first rule used for
Qos (Qualtiy of Service) rules applied for IP traffic.
If set to 0 or if there is no entry in the ipQoSTable with
this ind… | column | Integer32 | .0.3.1.28 |
| ipExtIfIpsecAccounting This object determines, whether packets which are en- or
decapsulated by IPSec should be accounted with encapsulation
header(ipsec) or without the encapsulation header (clear),
… | column | Enumeration | .0.3.1.29 |
| ipExtIfRipSend specifies which versions of RIP messages are sent
to that interface. Usually RIP messages are sent as
broadcast, except this object is set to ripV2mcast. In
this case RIP V2 messa… | column | Enumeration | .0.3.1.3 |
| ipExtIfMulticast Enable that multicast frames are accepted
from that interface. | column | Enumeration | .0.3.1.30 |
| ipExtIfNatSilentDeny This object specifies - if NAT is enabled (see ipExtIfNat) -
whether incoming IP packets not passed by the NAT barrier
should answered with an ICMP Host Unreachable or TCP RST
mes… | column | Enumeration | .0.3.1.31 |
| ipExtIfNatPPTPXlat This object specifies - if NAT is enabled (see ipExtIfNat) -
whether PPTP (point to point protocol) connections are
translated. This is needed if there are more than one
PPTP clie… | column | Enumeration | .0.3.1.33 |
| ipExtIfTcpMssClamping This object specifies whether TCP MSS clamping is enabled
on the interface. -1 disables clamping, 0 clamps the MSS
depending on the interface MTU. A value > 0 will be used
as clam… | column | bytes Integer32 | .0.3.1.34 |
| ipExtIfNbdgmRelayAddress This object contains the destination IP address
to which Netbios Datagram request are forwarded by the
router. | column | RFC1155-SMIIpAddress | .0.3.1.35 |
| ipExtIfNatMaxSessions This object limits the maximum number of NAT sessions
on a interface. | column | Integer32 | .0.3.1.36 |
| ipExtIfAllowedPeers If this object is set to 'dhcpclients', the router refuses
to exchange data with hosts which are not DHCP clients
on this interface. If this object is set to 'all',
the router a… | column | Enumeration | .0.3.1.37 |
| ipExtIfNatFlush If this object in enabled NAT-Flushing is done else not.
NAT-Flushing means that the NAT Entries for this interface
will be deleted in the case of an OperStatus change to down or… | column | Enumeration | .0.3.1.38 |
| ipExtIfHttpRedirect If not set to 'disabled' all HTTP requests on this interface
will be directed either to the local HTTP daemon or HTTP proxy. | column | Enumeration | .0.3.1.39 |
| ipExtIfRipReceive specifies which versions of RIP messages are accepted
from that interface. RIP V2 messages are received
regardless if they are sent as broadcast or multicast. | column | Enumeration | .0.3.1.4 |
| ipExtIfWolRuleIndex This object defines the index of the first rule used for
Wake-On-LAN (WOL) that is applied for incoming and/or
outgoing traffic. If set to 0 or if there is no entry in
the ipWolRu… | column | Integer32 | .0.3.1.40 |
| ipExtIfProxyArp Switch for Proxy ARP on this interface. | column | Enumeration | .0.3.1.5 |
| ipExtIfNat This object can be used to switch NAT on and off for
a specific interface. | column | Enumeration | .0.3.1.6 |
| ipExtIfNatTcpTimeout TCP NAT entries vanish unconditionally after not being
used for the amount of time specified by this object
in seconds. | column | seconds Integer32 | .0.3.1.8 |
| ipExtIfNatOtherTimeout Non-TCP NAT entries vanish unconditionally after not being
used for the amount of time specified by this object
in seconds. | column | seconds Integer32 | .0.3.1.9 |