batteryLowNotification
BATTERY-MIB ·
.1.3.6.1.2.1.233.0.2
Object
notification
This notification can be generated when the current charge
(batteryActualCharge) or the current voltage
(batteryActualVoltage) of the battery falls below a
threshold defined by object batteryAlarmLowCharge or object
batteryAlarmLowVoltage, respectively.
Note that, typically, this notification is generated in a
state where the battery is still sufficiently charged to keep
the device(s) that it powers operational for some time.
If the charging state of the battery has become critical,
i.e., the device(s) powered by the battery must go to a
'sleep' or 'off' state, then the batteryCriticalNotification
should be used instead.
If the low charge or voltage has been detected for a single
cell or a set of cells of the battery and not for the entire
battery, then object batteryCellIdentifier should be set to
a value that identifies the cell or set of cells.
Otherwise, the value of object batteryCellIdentifier should
be set to the empty string when this notification is
generated.
The notification should not be sent again for the same
battery or cell before either (a) the current voltage or
the current charge, respectively, has become higher than the
corresponding threshold through charging or (b) an indication
of a maintenance action has been detected, such as a battery
disconnection event or a reinitialization of the battery
monitoring system.
This notification should not be sent when the battery is in
a charging mode, i.e., the value of object
batteryChargingOperState is charging(2).
Context
- MIB
- BATTERY-MIB
- OID
.1.3.6.1.2.1.233.0.2- Type
- notification
- Status
- current
- Parent
- batteryNotifications
- Siblings
- 6
Syntax
No syntax metadata recorded.
Values & Constraints
No enumerated values or constraints recorded.
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| batteryChargingStateNotification This notification can be generated when a charging state
of the battery (indicated by the value of object
batteryChargingOperState) is triggered by an event other
than a write act… | notification | - | .1.3.6.1.2.1.233.0.1 |
| batteryCriticalNotification This notification can be generated when the current charge
of the battery falls so low that it cannot provide a
sufficient power supply function for regular operation
of the power… | notification | - | .1.3.6.1.2.1.233.0.3 |
| batteryTemperatureNotification This notification can be generated when the measured
temperature (batteryTemperature) rises above the threshold
defined by object batteryAlarmHighTemperature or falls
below the th… | notification | - | .1.3.6.1.2.1.233.0.4 |
| batteryAgingNotification This notification can be generated when the actual
capacity (batteryActualCapacity) falls below a threshold
defined by object batteryAlarmLowCapacity
or when the charging cycle co… | notification | - | .1.3.6.1.2.1.233.0.5 |
| batteryConnectedNotification This notification can be generated when it has been
detected that a battery has been connected. The battery
can be identified by the value of object batteryIdentifier
as well as … | notification | - | .1.3.6.1.2.1.233.0.6 |
| batteryDisconnectedNotification This notification can be generated when it has been
detected that one or more batteries have been disconnected. | notification | - | .1.3.6.1.2.1.233.0.7 |
Notification Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| batteryActualCharge This object provides the actual charge of the battery
in units of mAh.
Note that the actual charge needs to be measured and is
typically an estimate based on observ… | column | milliampere hours SNMPv2-SMIUnsigned32 | .1.3.6.1.2.1.233.1.1.1.15 |
| batteryActualVoltage This object provides the actual voltage of the battery
in units of mV.
A value of 'ffffffff'H indicates that the actual voltage
cannot be determined. | column | millivolt SNMPv2-SMIUnsigned32 | .1.3.6.1.2.1.233.1.1.1.16 |
| batteryCellIdentifier The value of this object identifies one or more cells of a
battery. The format of the cell identifier may vary between
different implementations. It should uniquely identify one… | column | SNMP-FRAMEWORK-MIBSnmpAdminString | .1.3.6.1.2.1.233.1.1.1.25 |