atFilev2DeleteBegin

A read on this object can return several possible values,
depending on the current status of the system and the various
file operation objects:
          
idle                               There is no file operation
                                   in progress and all required
                                   objects have been set
                                   correctly. Setting a '1' to
                                   this object will begin the
                                   file deletion.
          
Error codes: [1-3]                 A delete operation cannot be
                                   started until these errors
                                   are resolved. See below for
                                   key.
          
[action]ing x [--> y]              A file operation is
                                   currently in progress. You
                                   cannot start another
                                   operation while the object
                                   is returning this value.
          
[action] x [--> y] success         The last copy, move or
                                   delete operation was
                                   successfully completed.
          
[action] x [--> y] failure: [err]  The last copy, move or
                                   delete operation failed,
                                   with the error message
                                   attached. Common failures
                                   include lack of space on the
                                   destination file system,
                                   incorrect source file names
                                   or communication errors with
                                   remote services.
          
Upon reading a success or failure message, the message will be
cleared and the next read will result in either an 'idle'
message or an 'Error codes' message if not all required objects
have been correctly set. If a read returns 'idle', a new file
operation can be started.
          
File deletion operations ignore the values set in the
atFilev2DestinationStackID, atFilev2DestinationDevice and
atFilev2DestinationFilename objects.
          
Error codes for file deletion:
          
1 - atFilev2SourceDevice has not been set
2 - atFilev2SourceFilename has not been set
3 - atFilev2SourceDevice has been set to TFTP
          
Note that if the above requirements are met and the operation
would result in a system file being deleted, then an SNMP set
to this object will be disallowed.
          
For valid operations, immediately upon executing the SNMP set
operation on this object, the file deletion will begin and will
continue on the device until either it has completed, or a
failure occurs. For large files, operations can take several
minutes to complete.
          
Subsequent reads of the object will return one of the messages
shown above, to track the progress of the deletion operation.

MIB

AT-FILEv2-MIB

OID

.1.3.6.1.4.1.207.8.4.4.4.600.3.9

Type

scalar

Access

readwrite

Status

current

Parent

atFilev2FileOperation

Siblings

14