fsipv6Nd6MaxCacheEntries
ARICENT-IPV6-MIB ·
.1.3.6.1.4.1.2076.28.1.1.14
Object
Maximum Number of ND Cache Entries.
Context
- MIB
- ARICENT-IPV6-MIB
- OID
.1.3.6.1.4.1.2076.28.1.1.14- Type
- scalar
- Access
- readwrite
- Status
- current
- Parent
- fsipv6Scalars
- Siblings
- 24
Syntax
SNMPv2-SMIUnsigned32
- Source
- SNMPv2-SMIUnsigned32
- Base type
Unsigned32
Values & Constraints
Type Constraints
range: 0..4294967295
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| fsipv6NdCacheMaxRetries This object specifies the maximum number of retries
that can be attempted upon resolving the 'physical'
address of an IPv6 address during address resolution
or unreachability dete… | scalar | Integer32 | .1.3.6.1.4.1.2076.28.1.1.1 |
| fsipv6MaxLogicalIfaces Maximum Number of configurable Logical IPv6 Interfaces | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.28.1.1.10 |
| fsipv6MaxTunnelIfaces Maximum Number of configurable Tunnel Interfaces | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.28.1.1.11 |
| fsipv6MaxAddresses Maximum Number of Configurable IPv6 Interfaces. | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.28.1.1.12 |
| fsipv6MaxFragReasmEntries This object could be used for 2 purpose.
1. Maximum Number of IP6 datagrams awaiting reassembly.
2. Maximum Number of fragments that could be allowed in
a single reassembly li… | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.28.1.1.13 |
| fsipv6PmtuMaxDest Maximum Number of PMTU Table Entries | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.28.1.1.15 |
| fsipv6RFC5095Compatibility When the IPv6 node is configured to be RFC5095 compatible,
then it should treat Type 0 Routing Header as invalid
routing header type. | scalar | Enumeration | .1.3.6.1.4.1.2076.28.1.1.16 |
| fsipv6RFC5942Compatibility When the IPv6 node is configured to be RFC5942, ISS compatible
with RFC 5942 and prefix can be configured as on-link and off-link. | scalar | Enumeration | .1.3.6.1.4.1.2076.28.1.1.17 |
| fsipv6SENDSecLevel This Object specifies the sec level value for CGA generation in Secure Neighbor Discovery.
Note: For Sec values greater than zero, the above algorithm does not guaranty to termina… | scalar | Integer32 | .1.3.6.1.4.1.2076.28.1.1.18 |
| fsipv6SENDNbrSecLevel This object specifies the sec level that are accepted from neighbors in Secure Neighbor
Discovery.
Note: CGA verification should be able to process all security parameter values, … | scalar | Integer32 | .1.3.6.1.4.1.2076.28.1.1.19 |
| fsipv6PmtuConfigStatus Flag to enable or disable Path MTU Discovery for the node. | scalar | Enumeration | .1.3.6.1.4.1.2076.28.1.1.2 |
| fsipv6SENDAuthType This object specifies the authorisation type to be used. The options include;
0 indicates only CGA authorisation is required.
1 indicates only CA authorisation is required.
2 i… | scalar | Enumeration | .1.3.6.1.4.1.2076.28.1.1.20 |
| fsipv6SENDMinBits This object specifies the minimum acceptable key length.
Note: Only 512 and 1024 bits key support available in ISS | scalar | Enumeration | .1.3.6.1.4.1.2076.28.1.1.21 |
| fsipv6SENDSecDAD In mixed mode Secure Neighbour Discovery, when enabled it indicates secured advertisements
are only accepted for first tentative address. When disabled it indicates unsecured
adv… | scalar | Enumeration | .1.3.6.1.4.1.2076.28.1.1.22 |
| fsipv6SENDPrefixChk This object specifies the prefix and range check status. In Secure Neighbor Discovery When
enabled it indicates prefix and range checks are relaxed in host. When disabled it
ind… | scalar | Enumeration | .1.3.6.1.4.1.2076.28.1.1.23 |
| fsipv6ECMPPRTTimer Timer value for ECMP PRT. | scalar | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2076.28.1.1.24 |
| fsipv6NdCacheTimeout Time after which the entry in cache is deleted. | scalar | Integer32 | .1.3.6.1.4.1.2076.28.1.1.25 |
| fsipv6PmtuTimeOutInterval The time in minutes after which the path MTU entry times out. | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.28.1.1.3 |
| fsipv6JumboEnable Flag to enable or disable IPv6 Jumbogram facility for the node. | scalar | Enumeration | .1.3.6.1.4.1.2076.28.1.1.4 |
| fsipv6NumOfSendJumbo Number of IPv6 Jumbograms sent from the node. | scalar | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2076.28.1.1.5 |
| fsipv6NumOfRecvJumbo Number of IPv6 Jumbograms received. | scalar | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2076.28.1.1.6 |
| fsipv6ErrJumbo Number of IPv6 Error Jumbograms received or transmitted. | scalar | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2076.28.1.1.7 |
| fsipv6GlobalDebug Enables the tracing in the selected submodule in IP6. A 32 bit
integer is used to store the Tracing level in the specified module.
Different Tracing Levels -
BIT 0 - Initialisa… | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.28.1.1.8 |
| fsipv6MaxRouteEntries Maximum Number of Route Entries that could be configured in
the system. Minumum value is 5. | scalar | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.28.1.1.9 |