fsbgp4GRMode
ARICENT-BGP-MIB ·
.1.3.6.1.4.1.2076.41.1.19
Object
scalar
Enumeration
This object indicates whether the BGP speaker is restarting speaker or receiving speaker.
Context
- MIB
- ARICENT-BGP-MIB
- OID
.1.3.6.1.4.1.2076.41.1.19- Type
- scalar
- Access
- readonly
- Status
- current
- Parent
- fsbgp4Scalars
- Siblings
- 38
Syntax
Enumeration
Values & Constraints
Enumerated Values
1 | restarting |
2 | receiving |
3 | none |
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| fsbgp4GlobalAdminStatus The desired state of the BGP system. The BGP4 speaker is
functionally active only when the global admin status is up. The global
admin status can be made up only if the fsbgp4Loca… | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.1 |
| fsbgp4MaxPeerEntry The Maximum number of peers supported by BGP. This object can be set only
if fsbgp4LocalAs has been configured.
This object can not be set to a higher value than the initial value… | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.10 |
| fsbgp4MaxNoofRoutes It represents the maximum number of routes in the routing table. This
object can be set only if fsbgp4LocalAs has been configured.
This object can not be set to a higher value tha… | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.11 |
| fsbgp4AlwaysCompareMED If this object is set to disable, then in best route decision process,
MED will be compared only between routes received from the same
autonomous system. If set to enable, irrespe… | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.12 |
| fsbgp4DefaultOriginate If this object is set to enable/disable the redistribution and
advertisement of the default route (0.0.0.0/0). By default, the
default routes are not redistributed into BGP. Only … | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.13 |
| fsbgp4DefaultIpv4UniCast If this object is set to enable, and if a neighbor is created, then
the MP IPv4 Unicast Address Family Capability will be negotiate for
that peer. If this object is set as disable… | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.14 |
| fsbgp4GRAdminStatus This object is used to enable or disable GR capability in BGP speaker. | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.15 |
| fsbgp4GRRestartTimeInterval This is the estimated time (in seconds) it will take for the BGP
session to be re-established after a restart. Suggested default value
should be less than or equal to Hold Time … | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.16 |
| fsbgp4GRSelectionDeferralTimeInterval This interval is the upper bound on the amount of time a router
defers its route selection. The value of this timer should be large
enough, so as to provide all the peers of the… | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.17 |
| fsbgp4GRStaleTimeInterval This interval is the upper bound on the amount of time a router retains
the stale routes.
The GR stale time interval configured can be used only for the new peers
ses… | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.18 |
| fsbgp4LocalAs The local autonomous system number.This object can be set only if
fsbgp4GlobalAdminStatus is down. | scalar | Unsigned32 | .1.3.6.1.4.1.2076.41.1.2 |
| fsbgp4RestartSupport This object specifies the router's support for BGP graceful restart.
The Options include: no restart support, only planned restarts, or
both planned and unplanned restarts. This o… | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.20 |
| fsbgp4RestartStatus Current status of BGP graceful restart, it indicates whether the speaker
restarted or not if it is restarted whether it is a planned restart or unplanned restart | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.21 |
| fsbgp4RestartExitReason Describes the outcome of the last attempt at a graceful restart.
If the value is 'none': no restart has yet been attempted.
'inProgress': a restart attempt is currently underwa… | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.22 |
| fsbgp4RestartReason The router's restarter reason of BGP graceful restart.
Options include: unknown,softwarerestart,swreloadupgrade.
This object is persistent and when written
the entity SHOULD sa… | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.23 |
| fsbgp4ForwardingPreservation This object indicates whether the forwarding plane is preserved during restart or not | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.24 |
| fsbgp4IsTrapEnabled If this object is set to disable, then the NOTIFICATION messages wont be sent to
the SNMP Manager. If enabled, NOTIFICATION messages are sent. | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.25 |
| fsbgp4NextHopProcessingInterval This object is used to configure the interval at which next hops will be mointored for reachablity | scalar | SNMPv2-SMIInteger32 | .1.3.6.1.4.1.2076.41.1.26 |
| fsbgp4IBGPRedistributionStatus If this object is set to enable, IBGP routes will also be redistributed to other
IGP protocols when redistribution is enabled for that protocol | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.27 |
| fsbgp4IBGPMaxPaths Maximum number of internal BGP multipath routes to be added per destination network in Routing table.
When this object takes the value 1, then only best route is added to Forwardi… | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.28 |
| fsbgp4EBGPMaxPaths Maximum number of external BGP multipath routes to be added per destination network in Routing table.
When this object takes the value 1, then only best route is added to Forwardi… | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.29 |
| fsbgp4Identifier This object configures the BGP Identifier of local system. If global
admin status is made up, by default the BGP Identifier will take
the value of highest interface address. If th… | scalar | SNMPv2-SMIIpAddress | .1.3.6.1.4.1.2076.41.1.3 |
| fsbgp4EIBGPMaxPaths Maximum number of external plus internal BGP multipath routes (with same AS PATH) to be
added per destination network in Routing table.
When this object takes the value 1, then o… | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.30 |
| fsbgp4OperIBGPMaxPaths Operational value for Maximum number of internal BGP multipath routes to be added per destination network
in Routing table.
When this object takes the value 1, then only best rou… | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.31 |
| fsbgp4OperEBGPMaxPaths Operational value for Maximum number of external BGP multipath routes that to be added per
destination network in Routing table.
When this object takes the value 1, then only bes… | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.32 |
| fsbgp4OperEIBGPMaxPaths Operational value for Maximum number of external plus internal BGP multipath routes
(with same AS PATH) to be added per destination network in Routing table.
When this object… | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.33 |
| fsbgp4FourByteASNSupportStatus This object is used to enable or disable 4 byte ASN support in BGP Speaker.
This can be configured only if fsbgp4GlobalAdminStatus is down. | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.34 |
| fsbgp4FourByteASNotationType This object denotes the notation to be used to display the 4 byte ASN. This
will change only the way the AS number is represented within router show
commands in the Command Line I… | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.35 |
| fsbgp4VpnLabelAllocPolicy This object denotes the Label Allocation policy. | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.36 |
| fsbgp4MacMobDuplicationTimeInterval This interval is the upper bound on the amount of time a VM
Moved among the PEs for about MaxMacMoves times. | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.37 |
| fsbgp4MaxMacMoves This is the Maximum number of times a VM(MAC) can be moved among PEs
before the Mac Duplication timer Interval expiry | scalar | Integer32 | .1.3.6.1.4.1.2076.41.1.38 |
| fsbgp4VpnRouteLeakStatus This object is used to enable/disable the VRF route leaking between two different VRFS. | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.39 |
| fsbgp4Synchronization Attribute to enable/disable synchronization within an AS.
This object can be set only if fsbgp4LocalAs has been configured. | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.4 |
| fsbgp4DefaultLocalPref The default value of local-pref that is to be sent in updates to internal
peers.This object can be set only if fsbgp4LocalAs has been configured. | scalar | Unsigned32 | .1.3.6.1.4.1.2076.41.1.5 |
| fsbgp4AdvtNonBgpRt This mib object can be used to configure the peer type to whom
non-bgp routes can be propagated.
external - indicates non-bgp routes can be exported to only
… | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.6 |
| fsbgp4TraceEnable This object can be used to enable trace dynamically in BGP
module. A four byte integer value is specified for enabling
the level of tracing.Each Bit in the four byte integer varia… | scalar | Unsigned32 | .1.3.6.1.4.1.2076.41.1.7 |
| fsbgp4DebugEnable This object can be used to enable debug dynamically in BGP module.
Its a four byte integer value specified for enabling the level
of debugging. Each Bit in the four byte integer v… | scalar | Unsigned32 | .1.3.6.1.4.1.2076.41.1.8 |
| fsbgp4OverlappingRoute This object is used to configure the BGP speaker's policy for handling
the overlapping routes. When an overlapping route is received, depending
upon the configured policy either t… | scalar | Enumeration | .1.3.6.1.4.1.2076.41.1.9 |