fsBgp4PeerGroupIdleHoldTimeConfigured
ARICENT-BGP-MIB ·
.1.3.6.1.4.1.2076.41.40.1.11
Object
column
r/w
Integer32
IdleHoldTime specifies the length of time the BGP peers in this peer group is held in Idle state prior to allowing the next automatic restart. The IdleHoldTime is configured only when the fsBgp4PeerGroupAllowAutomaticStart is Enabled or when the fsBgp4PeerGroupDampPeerOscillations is Enabled. The configurable value differs based on the two options that are enabled.The Suggested default value is 60 secs for automatic start. After each dampening, the value of the IdleHoldTime is doubled consecutively.
Context
- MIB
- ARICENT-BGP-MIB
- OID
.1.3.6.1.4.1.2076.41.40.1.11- Type
- column
- Access
- readwrite
- Status
- current
- Parent
- fsBgp4PeerGroupEntry
- Table
- fsBgp4PeerGroupTable
- Siblings
- 37
Syntax
Integer32
Values & Constraints
Object Constraints
range: 1-65535
Related Objects
Sibling Objects
| Object | Type | Syntax | OID |
|---|---|---|---|
| fsBgp4PeerGroupName The group name for this peer group entry. | column | OctetString | .1.3.6.1.4.1.2076.41.40.1.1 |
| fsBgp4PeerGroupAllowAutomaticStop This MIB object specifies whether BGP session with the peers in the
peer group need to be automatically stopped after a TCP connect-retry
count value specified by 'fsBgp4PeerGrou… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.10 |
| fsBgp4PeerGroupDampPeerOscillations The DampPeerOscillations option specifies that the implementation
engages additional logic to damp the oscillations of BGP peers in
the face of series of automatic start and autom… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.12 |
| fsBgp4PeerGroupDelayOpen This MIB object allows configuration option to enable/disable delay
in sending of OPEN messages to the BGP peers for a specific time period
(DelayOpenTime). The delay allows the r… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.13 |
| fsBgp4PeerGroupDelayOpenTimeConfigured The DelayOpen time specifies the amount of time the BGP Peers should
delay in sending the OPEN message to the remote peers. If the
fsBgp4PeerGroupDelayOpen option is enabled, the … | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.14 |
| fsBgp4PeerGroupPrefixUpperLimit BGP speaker imposes a locally-configured, upper bound on the number of
address prefixes the speaker is willing to accept from a neighbor. The
default value is calculated as the fo… | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.15 |
| fsBgp4PeerGroupTcpConnectRetryCnt This counter denotes the Maximum number of times the BGP Peers have
tried to issue a TCP-Connect with its neighboring peers.
The default value for the counter is set as 5. | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.16 |
| fsBgp4PeerGroupEBGPMultiHop This objects enables the BGP4 Speaker to accept or attempt
connections to external peers residing on network that are not directly
connected. By default, only directly connected E… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.17 |
| fsBgp4PeerGroupEBGPHopLimit This objects enables the BGP4 Speaker to accept or attempt
connections to external peers residing on network that are not directly
connected and seperated by a maximum hop limit a… | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.18 |
| fsBgp4PeerGroupNextHopSelf This object specifies how the next hop attribute sent in the update
messages to the peers in this peer group. When the object takes the
value of self,the next Hop attribute will … | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.19 |
| fsBgp4PeerGroupAddrType The address type of the peers added to this peer group. | column | InetAddressType | .1.3.6.1.4.1.2076.41.40.1.2 |
| fsBgp4PeerGroupRflClient This object specifies whether the peers in this peer group are
Client peers or Non-Client peers. By default, the peers are
created as Non-Client Peer. | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.20 |
| fsBgp4PeerGroupTcpSendBufSize This object configures the tcp window size on the sender side
for all the peers in this peer group. | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.21 |
| fsBgp4PeerGroupTcpRcvBufSize This object configures the tcp window size on the receiver side
for all the peers in this peer group. | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.22 |
| fsBgp4PeerGroupCommSendStatus Community Send status for the peers in this peer group.
o none - is for read-only
o send - send communities to this peer
o donotsend - do not send communities to this… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.23 |
| fsBgp4PeerGroupECommSendStatus Extended Community Send status for the peers in this peer group.
o none - is for read-only
o send - send extended communities to this peer
o donotsend - do not send ext… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.24 |
| fsBgp4PeerGroupPassive This object is used to set the peers in this group to be active,
that means the speaker will not initiate the session with the peers
instead it waits for the remote peers to initi… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.25 |
| fsBgp4PeerGroupDefaultOriginate This object is used to enable/disable the advertisement
of the default route to all the peers in this peer group.
This object overrides the global default route configuration
(fs… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.26 |
| fsBgp4PeerGroupActivateMPCapability This object is set to activate the corresponding MP Capability.
If any of MP Capability is activated, then this capability should
be negotiated while establishing session with the… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.27 |
| fsBgp4PeerGroupDeactivateMPCapability This object is set to deactivate the corresponding MP Capability.
If any of MP Capability is deactivated, then this capability should
not be negotiated while establishing session … | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.28 |
| fsBgp4PeerGroupRouteMapNameIn This object is used to configure the in routemap for this peer group entry. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.2076.41.40.1.29 |
| fsBgp4PeerGroupRemoteAs The remote autonomous system number for this peer group. | column | Unsigned32 | .1.3.6.1.4.1.2076.41.40.1.3 |
| fsBgp4PeerGroupRouteMapNameOut This object is used to configure the out routemap for this peer group entry. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.2076.41.40.1.30 |
| fsBgp4PeerGroupStatus This object is used to create the peer group or delete the group. | column | SNMPv2-TCRowStatus | .1.3.6.1.4.1.2076.41.40.1.31 |
| fsBgp4PeerGroupIpPrefixNameIn This object is used to configure the IP Prefix list name in IN direction for this peer group entry. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.2076.41.40.1.32 |
| fsBgp4PeerGroupIpPrefixNameOut This object is used to configure the IP Prefix list name in OUT direction for this peer group entry. | column | SNMPv2-TCDisplayString | .1.3.6.1.4.1.2076.41.40.1.33 |
| fsBgp4PeerGroupOrfType This object is used to configure the ORF type supported for this peer group entry.
This object should be set before enabling the ORF mode fsBgp4PeerGroupOrfCapMode.
Now the Addres… | column | SNMPv2-SMIUnsigned32 | .1.3.6.1.4.1.2076.41.40.1.34 |
| fsBgp4PeerGroupOrfCapMode This object is used to configure the ORF Capability mode supported for this peer group entry.
If it is set to ZERO, then the both ORF modes will be disabled | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.35 |
| fsBgp4PeerGroupOrfRequest This object is to trigger the ORF messages to the peers associated with this peer group entry.
Once the ORF messags are transmitted, this object will be cleared.
Get operation of … | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.36 |
| fsBgp4PeerGroupBfdStatus This object is used to enable or disable BFD monitoring for the BGP peer group.
When this is enabled BGP will register with BFD for all the BGP peers added in this group,
once the… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.37 |
| fsBgp4PeerGroupOverrideCapability This object is used to enable or disable Override Capability for the BGP peer group. | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.38 |
| fsBgp4PeerGroupHoldTimeConfigured Time interval (in seconds) for the Hold Time configured for this
BGP speaker with all the peers configured for this group.
This value is placed in an OPEN message sent to the pe… | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.4 |
| fsBgp4PeerGroupKeepAliveConfigured Time interval (in seconds) for the KeepAlive timer configured for this
BGP speaker with all the peers configured in this group. The value
of this object will only determine the … | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.5 |
| fsBgp4PeerGroupConnectRetryInterval Time interval in seconds for the ConnectRetry timer for the peers
in this group. The suggested value for this timer is 120 seconds. | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.6 |
| fsBgp4PeerGroupMinASOriginInterval Time interval (in seconds) for the MinASOriginationInterval
timer for all peers configured in this group.
The suggested value for this timer is 15 seconds. | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.7 |
| fsBgp4PeerGroupMinRouteAdvInterval Time interval (in seconds) for the MinRouteAdvertisementInterval timer.
The suggested value for this timer is 30 seconds for EBGP connections
and 5 seconds for IBGP connections. | column | Integer32 | .1.3.6.1.4.1.2076.41.40.1.8 |
| fsBgp4PeerGroupAllowAutomaticStart This MIB object specifies whether BGP session with the peers in the
peer group can be started automatically. This object when set to
'disabled', requires manual start for initiat… | column | Enumeration | .1.3.6.1.4.1.2076.41.40.1.9 |