alaOspfRestartInterval

ALCATEL-IND1-OSPF-MIB · .1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.27
MIB view Table view

Object

scalar r/w seconds Integer32 
Configured OSPF hitless restart timeout interval.

Context

MIB
ALCATEL-IND1-OSPF-MIB
OID
.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.27
Type
scalar
Access
readwrite
Status
current
Units
seconds
Parent
alaProtocolOspf
Siblings
38

Syntax

seconds Integer32

Values & Constraints

Object Constraints
range: 1-1800

Related Objects

Sibling Objects
ObjectTypeSyntaxOID
alaOspfRedistAdminStatus deprecated
Enable or disable redistribution of routes into OSPF. This object has been deprecated. Use the alaRouteMapRedistProtoEntry objects of AlcatelIND1RouteMap.mib.
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.1
alaOspfRedistProtoTable deprecated
Protocol based configuration for route redistribution using OSPF. This table has been deprecated. Use the alaRouteMapRedistProtoTable of AlcatelIND1RouteMap.mib.
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.10
alaOspfRouteTable
OSPF routing table which contains the network routes.
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.12
alaOspfBdrRouterTable
OSPF routing table which contains the routes to border (ABR and ASBR) routers.
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.13
alaOspfRedistRouteTable deprecated
A configuration table which controls the routes to be redistributed by OSPF from other routing protocols. This table has been deprecated. Use the alaRouteMapRedistProtoTable of Al…
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.14
alaOspfIfMd5Table
The OSPF Interface MD5 Table describes the MD5 key management for OSPF interfaces.
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.16
alaOspfIfAugTable
Expansion for ospfIfTable
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.17
alaOspfVirtIfAugTable
Expansion for ospfVirtIfTable
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.18
alaOspfRestartHelperSupport
The router's support for acting as an OSPF hitless restart helper.
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.19
alaOspfRedistRouteTag
A 32-bit value tagged to each OSPF internal route that is redistributed in to other routing protocol domains. The lower 16-bits typically indicate the autonomous system number.
scalarInteger32.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.2
alaOspfRestartHelperStrictLSAChecking
Indicates whether or not a changed LSA will result in termination of graceful restart by a helping router.
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.20
alaOspfRestartHelperStatus
Indicates whether this OSPF router is operating as a Helper to a restarting router.
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.21
alaOspfRFC1583Compatibility
Indicates metrics used to choose among multiple AS- external-LSAs. When RFC1583Compatibility is set to enabled, only cost will be used when choosing among multiple AS-external-LSA…
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.22
alaOspfOpaqueLsaSupport
The router's support for Opaque LSA types.
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.23
alaOspfTrafficEngineeringSupport
The router's support for OSPF traffic engineering.
scalarSNMPv2-TCTruthValue.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.24
alaOspfReferenceBandwidth
Reference bandwidth in kilobits/second for calculating default interface metrics. The default value is 100,000 KBPS (100 MBPS)
scalarSNMPv2-SMIUnsigned32.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.25
alaOspfRestartSupport
The router's support for OSPF hitless restart. Options include: no restart support, only planned restarts or both planned and unplanned restarts.
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.26
alaOspfRestartStatus
Current status of OSPF hitless restart. The status of hitless restart is unplannedRestart after a CMM takeover. Before CMM takeover, the status is plannedRestart.
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.28
alaOspfRestartAge
Remaining time in current OSPF hitless restart interval.
scalarseconds SNMPv2-SMIUnsigned32.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.29
alaOspfTimerSpfDelay
Number of seconds to delay the SPF calculation after receiving a topology change. This value should not be greater than SPF hold time.
scalarInteger32.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.3
alaOspfRestartExitReason
Describes the outcome of the last attempt at a hitless restart. If the value is 'none', no restart has yet been attempted. If the value is 'inProgress', a restart attempt is curre…
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.30
alaOspfNbrAugTable
Extensions to the ospfNbrTable
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.31
alaOspfVirtNbrAugTable
Extensions to ospfVirtNbrTable
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.32
alaOspfRestartInitiate
Initiates a planned graceful restart, if set to plannedRestart.
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.33
alaOspfAreaAugTable
Extensions to ospfAreaTable
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.35
alaOspfExtLsdbAugTable
Extensions to ospfExtLsdbTable
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.36
alaOspfAreaInterfaceTable obsolete
This table holds the mapping between area ID and the interfaces attached to it
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.37
alaOspfAreaAggregateAugTable
Extensions to ospfAreaAggregateTable
table-.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.38
alaOspfDefaultOriginate
Indicates whether this ASBR router originates the default route into the OSPF normal area(s). If set to 'only', the default route is advertised into the OSPF normal area, provi…
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.39
alaOspfTimerSpfHold
Minimum time, in seconds, between two consecutive SPF calculations. This value should not be less than SPF delay time.
scalarInteger32.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.4
alaOspfDefaultOriginateMetricType
Type of metric to be used with the default route.
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.40
alaOspfDefaultOriginateMetric
Default metric to be used for the default route.
scalarInteger32.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.41
alaOspfBfdStatus
Enables or disables bfd for OSPF protocol
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.42
alaOspfBfdAllInterfaceStatus
Enables or disables bfd for all OSPF interfaces
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.43
alaOspfOpaqueTransitCapability
Enables or disables opaque LSA accept and retransmit capability for OSPF
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.44
alaOspfRouteNumber
The number of network routes in OSPF routing table.
scalarSNMPv2-SMICounter32.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.7
alaOspfMTUCheck
Enable or disable the check for MTU size in database description packets. Disabled by default
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.8
alaOspfAsBdrRtr deprecated
Enable or disable the switch being configured as an ASBR (Autonomous System Border Router. NOT SUPPORTED - Use IETF_OSPF.mib variable ospfASBdrRtrStatus.
scalarEnumeration.1.3.6.1.4.1.6486.800.1.2.1.10.4.1.1.1.9