WR-SWITCH-MIB Table View

Index for wrsDiskTable

Mount patch of reported partition

Partition size

Used space on partition

Free space on partition

Percentage of used space on partition

Filesystem reported by df command

Index for wrsPtpDataTable

Port name on which servo instance is running

The ClockID of the current grandmaster

The ClockID of this WR device

The mode of this clock

The servo state if slave

Numeric representation of servo state

Whether phase tracking is enabled in the servo

The interface name that is currently the synchronization source

Absolute value of current clock offset from master, in picoseconds

Human Readable current clock offset from master, in picoseconds with saturation to integer

The estimated change of master-to-slave delay, in picoseconds

The round-trip-time, from master, in picoseconds

Estimated fiber length, from master-to-slave delay, in meters

How many time did the servo run

Fixed Tx latency on Master side

Fixed Rx latency on Master side

Fixed Tx latency on Slave side

Fixed Rx latency on Slave side

Number of servo updates with wrong servo state

Number of servo updates with wrong clock offset

Number of servo updates with wrong RTT

TAI Nanosecond of the last servo's update

Extension with which the servo runs.

Index for wrsPortStatusTable

Name of port

Whether the link is up or down

Whether the port is configured as master, slave, non-wr or auto

Whether the peers are locked or not

the ClockID of the peer, if available. Or 0

Vendor Name of SFP

Part Number of SFP

Vendor serial number of SFP

Whether the SFP is in data base or not

Whether the SFP is 1 GbE

Problem with SFP configuration. Port has to be always 1GbE. Port has to be in data base as long as support WR.

Number of transmitted PTP frames per port (for all PPSI instances
running on particular port

Number of received PTP frames per port (for all PPSI instances
running on particular port

If disable, SNMP will not generate any errors for this port.

SFP plugged into a given port has extra monitoring (DOM) capabilities.

Temperature reported by SFP. According to SFF-8472, accuracy of
this value must be better than 3 degrees Celsius

Internally measured transceiver supply voltage reported by SFP.
According to SFF-8472, accuracy of this value must be better than 3%

Measured TX bias current in uA reported by SFP.
According to SFF-8472, accuracy of this value must be better than 10%

Measured TX output power in uW reported by SFP.
According to SFF-8472, accuracy of this value must be better than 3dB%

Measured RX output power in uW reported by SFP.
According to SFF-8472, accuracy of this value must be better than 3dB%

T2/T4 phase transition point used for Rx timestamps correction

Validity of wrsPortStatusT24p

Index for wrsPstatsHCTable

Port name of port

Number of TX underrun errors

Number of RX overrun errors

Number of received invalid 8B10B code errors

Number of RX link synchronization lost

Number of received pause frames

Number of received frames dropped at pfilter

Number of errors occurred during frame reception in PCS

Number of received giant frames
(bigger than Maximum Receive Unit)

Number of received runt frames
(smaller than 64bytes)

Number of RX CRC errors

Number of received frames assigned to
class 0 by packet filter in endpoint

Number of received frames assigned to
class 1 by packet filter in endpoint

Number of received frames assigned to
class 2 by packet filter in endpoint

Number of received frames assigned to
class 3 by packet filter in endpoint

Number of received frames assigned to
class 4 by packet filter in endpoint

Number of received frames assigned to
class 5 by packet filter in endpoint

Number of received frames assigned to
class 6 by packet filter in endpoint

Number of received frames assigned to
class 7 by packet filter in endpoint

Number of transmitted frames

Number of received frames

Number of RX frames dropped due to RTU full

Number of RX frames at internal priority 0

Number of RX frames at internal priority 1

Number of RX frames at internal priority 2

Number of RX frames at internal priority 3

Number of RX frames at internal priority 4

Number of RX frames at internal priority 5

Number of RX frames at internal priority 6

Number of RX frames at internal priority 7

Number of valid RTU requests

Number of valid RTU responses

Number of frames dropped at RTU

Number of priority frames matched by fast match

Number of forwarded frames matched by fast match

Number of not forwarded frames matched by fast match

Number of fast match decisions

Number of full match decisions

Number of forwarded frames

Number of TRU decisions

Number of TX frames coming from CPU

Index for wrsPtpInstanceTable

Index for wrsPtpInstanceTable

Name of an instance

Port number on which an instance is running

Index of an instance running on a port

Port name of port

Name of instance

MasterOnly feature enabled/disabled

DesiredState to be used if/when externalPortConfiguration feature is enabled

Delay Mechanism type used by PTP Instance

Profile/Extension configured on a PTP Instance

Extension used on the PTP Instance

Asymmetry Corrections enabled/disabled on the PTP Instance

Constant Asymmetry in picoseconds

Scaled Relative Delay Coefficient

Relative Delay Coefficient in a floating form

Egress Latency (Tx Fixed Delay) in picoseconds

Ingress Latency (Rx Fixed Delay) in picoseconds

Semi-static latency (bitslide) in picoseconds

Protocol detection state

State of PTP extension (more than one are allowed per 1 physical port)

MAC used by an instance

VID used by an instance

Number of VLANs used by an instance

Comma separated list of VLANs used by an instance

PTP instance status error
ok - all SFPs are ok
error - there is an error in SFP
warningNA - at least one field is equal to 0 (NA),
shouldn't happen in normal operation