Juniper-UNI-IF-MIB Table View

This table contains a corresponding entry for each entry found in the
standard Generic Interfaces MIB ifTable/ifXTable.  The entries in this
table contain supplementary generic interface characteristics.
          
Entries in ifTable/ifXTable and in this table are created/deleted as a
consequence of hardware detection, or of management configuration via
standard or enterprise type-specific interface MIBs.

A table containing information on the relationships between the
multiple sub-layers of network interfaces.  In particular, it contains
information on which sub-layers run 'underneath' which other sub-layers,
where each sub-layer corresponds to a conceptual row in the ifTable.
For example, when the sub-layer with ifIndex value x runs underneath the
sub-layer with ifIndex value y, then this table contains:
          
      juniIfInvStackStatus.x.y = active
          
For each ifIndex value, I, which identifies an active interface, there
are always at least two instantiated rows in this table associated with
I.  For one of these rows, I is the value of ifStackHigherLayer; for the
other, I is the value of ifStackLowerLayer.  (If I is not involved in
multiplexing, then these are the only two rows associated with I.)
          
For example, two rows exist even for an interface which has no others
stacked on top or below it:
          
      ifStackStatus.x.0 = active
      ifStackStatus.0.x = active
          
This table contains exactly the same number of rows as the ifStackTable,
but the rows appear in a different order.

This table contains entries for each interface type's system wide
interfaces counts.