indicates that in order to perform the last SET request, a reset operation
of the router/bridge is required. This occurs when the layer 2 routing algorithm is
changed between SPF and Spanning Tree. The reset can be performed manually or
using the variable rndAction.

indicates that in the device finished a TFTP
transaction with the management station.
variable rndErrorDesc and rndErrorSeverity provides the actual message
text and severity respectively.

indicates that in the device aborted a TFTP session with
the management station. Variable rndErrorDesc  and rndErrorSeverity
provides the actual  message text  and severity  respectively.

mpleted trap is sent at the completion
of a sequence of pings if such a trap was requested
when the sequence was initiated. The trap severity is info.
The trap text will specify the following information:
rsPingCompletionStatus, rsPingSentPackets, rsPingReceivedPackets
In addition to the above listed objects (which are always present),
the message will also specify the following quantities:
if any responses were received:
   rsPingMinReturnTime
   rsPingAvgReturnTime
   rsPingMaxReturnTime

indicates that a PPP link got an unrecognized secret.
The bound variables rndErrorDesc,
rndErrorSeverity(== warning ), interface Number. and pppSecurityIdentity

nal trap indicating that the device has intiated a
TFTP session. rndErrorDesc will contain the file type in
question

ain server fails and backup takes over or server comes
up after failure a trap of this type is issued.

d to allocate an IP address to a requesting host
because of memory shortage or inadequate configuration of
available IP addresses.

The IP SFFT overflow.

The IP NFFT overflow.

The IPX SFFT overflow.

The IPX NFFT overflow.

The IPM FFT overflow.

that the physical decription of the device has
changed

s sent by a bridge when any of its configured ports
transitions from the Learning state to the Forwarding state.

s sent by a bridge when any of its configured ports
transitions from the Forwarding state to the Blocking state.

Indicates that the packet drop due to the policy

Indicates that the packet has forward based on policy

An IGMP PROXY Table overflow.

An IGMP Message of v1 received on ifIndex.

One or more VRRP entries deleted due to IP interface deletion or transition.

Hot swap trap.

Informational trap indicating that a port is added to a trunk

This warning is generated when a port removed from a trunk.

nal trap indicating that a port can not be added to
a trunk because of device limitations or diffrent swIfType.

nal trap indicating that a locked port receive
a frame with new source Mac Address.

add gvrp dynamic vlan

remove gvrp dynamic vlan

vlan status was changed from dynamic to static

vlan status was changed from static to dynamic

Controller receive trap from member , and forward it as trap

ating the fan state.
rndErrorSeverity will be:
       0 for fan state  nomal, notPresent
       1 for fan state warning, notFunctioning
       2 for fan state critical
       3 for fan state fatal
The error text will specify the fan index, fan description and the exact fan state

ating the power supply state.
rndErrorSeverity will be:
       0 for power supply state  nomal, notPresent
       1 for power supply state warning, notFunctioning
       2 for power supply state critical
       3 for power supply state fatal
The error text will specify the power supply index, power supply description and the exact power supply state

ating the stack connection state
0 for stack state connected,
1 for stack state disconnected

ating that the temperature in the device has exceeded the
device specific safe temperature threshold.

nal trap indicating that adding dynamic mac/s
failed due to full hash chain.

Informational trap indicating that port 802.1x status is authorized.

Warning trap is indicating that port 802.1x status is unAuthorized.

Warning trap is indicating port lock hase began.

Warning trap is indicating port lock has ended.

ap indicating that the user was locked after
number of consecutives unsuccessful login attempts.

Warning trap indicating - Port was suspended because there was BPDU Guard violation.

nal trap indicating that MAC authentication supplicant
is authenticated and is allowed to access the network.

ap is indicating that Radius server rejects
MAC authentication supplicant.

Warning trap indicating - A loopback was detected on port.

Warning trap indicating - A loopback detection resolved on port.

Warning trap indicating - A port has been suspended by Loopback Detection.

Warning trap indicating - A port has been suspended by Any application.

Warning trap indicating - Special BPDU DB Overflow.

ap is indicating that supplicant was logged out
Since the ports time-range state was changed to inactive.

ap is indicating that altough ports time-range
Is active now, it can not start working in mode auto.

ap indicating - Port has multiple LLDP remote link neighbours -
EEE operational state will be FALSE.

ap indicating - Port has single LLDP remote link neighbour -
EEE operational can be TRUE.

ap is indicating that supplicant quiet period timeout
is active now.

nal trap indicating that stack member is upgrading
to the image or boot version of the stack controller.

ap indicating that stack member is downgrading
to the image or boot version of the stack controller.

Automantic switchover to backup link because of main link fault.

Communication returened to main link.

Informational trap indicating that port in PD does not meet the inrush-current standard.

Informational trap indicating that Port (x) requires more power than it should require.

Informational trap indicating power negotiation resolved power in Watts.

Informational trap indicating power negotiation 4-Wire status.

Informational trap indicating power HW fail status.

Informational trap indicating power negotiation expired.

Warning trap indicating that port storm control rate limit is configured to minumum rate.

Informational trap indicating about backplane ethernet port resolution.

Informational trap indicating that gbic is now present on port (X).

Informational trap indicating that gbic is not present anymore on port (X).

Informational trap indicating that loss Diagnosed on port (X).

Informational trap indicating that loss isn't active anymore on port (X).

Warning trap indicating that port storm control occurs on a port.

Radius server accounting event trap.

Radius server authentication failure event trap.

Radius server authentication success event trap.

Trap indicating the redundant fan status change.

Informational trap indicating that 802.1x supplicant port status is authorized.

Warning trap indicating that 802.1x supplicant port status is unAuthorized.

Warning trap indicating that credential is changed, rejected or not updated.

Informational trap indicating Non POE Detected unit

Informational trap indicating CPLD update FW is in progress

s sent by a bridge when any of its configured ports
transitions to new inconsistency mode.

s sent by a bridge when any of its configured ports
transitions from inconsistency mode to resolved mode.

Warning trap indicating that non-compliant SFP is inserted on port (X).

Warning trap indicating power HW fail status on a port.

ap indicating HTTP-TLS X.509 certificate validation error of
Common-Name/Subject-Alternative-Name

Notification trap indicating invalid PoE single signature

Notification trap indicating invalid PoE double signature

Notification trap indicating denied PoE power

Notification trap indicating detected PoE SS BT port

Notification trap indicating detected PoE DS BT port

Notification trap indicating which PoE channel port is on

Notification trap indicating that the PoE BT port was demoted

er overflow has occurred in one of the LAN or link
interfaces. The bound variable rndErrorDesc provides the
interface number.

indicates that in an OpenGate IPX RIP table overflow.
The bound variable rndErrorDesc, rndErrorSeverity
provides the actual  message text and severity respectively.

indicates that in an OpenGate IPX SAP table overflow.
The bound variable rndErrorDesc, rndErrorSeverity
provides the actual  message text and severity respectively.

queue overflow has occurred in one of the LAN or link interfaces.
The bound variable rndErrorDesc provides the interface number.

indicates that message that fits FACS statenebt with
operation blockAndReport was forward to the interface. The bound
variable rndErrorDesc, rndErrorSeverity(== info ) and
interface Number.

w condition has occurred in the Routing Table. The Routing
Table is used for IP routing algorithm (RIP).

indicates that auto comfiguration completetd succssefully.
The bound variable rndErrorDesc, rndErrorSeverity(== info )

indicates that an overflow condition has occurred in the
layer II Forward Table.
The bound variable rndErrorDesc, rndErrorSeverity(== warning )

indicates that a connection establish between the Frame
relay Switch and the WanGate.
The bound variable rndErrorDesc, rndErrorSeverity(== warning )

indicates that a connection between the Frame Relay Switch
and the WanGate failed.
The bound variable rndErrorDesc, rndErrorSeverity(== warning )

indicates that the an error occured during initialization
The bound variable rndErrorDesc, rndErrorSeverity(== error )

This warning is generated when an overflow occurs in the clients table.

ng is generated when a server does not respond to the dispatchers polling
and is thought to be inactive.

The Zero Hop Routing connections Table has been overflown.

ted static connection was not accepted because there is
no available IP virtual address to allocate to it.

l IP address appeared as a source IP.
All the connections using it will be deleted and
it will not be further allocated to new connections.

 IP address sent an ARP specifying a virtual IP
which was not allocated for this source.
This virtual IP will not be allocated to connections of this
specific source IP.

g SNMP SET request was rejected because no such
requests (except action requests) are accepted after start of
new configuration reception or during sending the current
configuration to an NMS.