This trap indicates that in order to perform the last SET request, a reset operation
of the router/bridge is required. This occurs when the layer 2 routing algorithm is
changed between SPF and Spanning Tree. The reset can be performed manually or
using the variable rndAction.

This trap indicates that in the device finished a TFTP
transaction with the management station.
variable rndErrorDesc and rndErrorSeverity provides the actual message
text and severity respectively.

This trap indicates that in the device aborted a TFTP session with
the management station. Variable rndErrorDesc  and rndErrorSeverity
provides the actual  message text  and severity  respectively.

A rsPingCompleted trap is sent at the completion
of a sequence of pings if such a trap was requested
when the sequence was initiated. The trap severity is info.
The trap text will specify the following information:
rsPingCompletionStatus, rsPingSentPackets, rsPingReceivedPackets
In addition to the above listed objects (which are always present),
the message will also specify the following quantities:
if any responses were received:
   rsPingMinReturnTime
   rsPingAvgReturnTime
   rsPingMaxReturnTime

This trap indicates that a PPP link got an unrecognized secret.
The bound variables rndErrorDesc,
rndErrorSeverity(== warning ), interface Number. and pppSecurityIdentity

Informational trap indicating that the device has intiated a
TFTP session. rndErrorDesc will contain the file type in
question

Whenever main server fails and backup takes over or server comes
up after failure a trap of this type is issued.

DHCP failed to allocate an IP address to a requesting host
because of memory shortage or inadequate configuration of
available IP addresses.

The IP SFFT overflow.

The IP NFFT overflow.

The IPX SFFT overflow.

The IPX NFFT overflow.

The IPM FFT overflow.

Indicates that the physical decription of the device has
changed

The trap is sent by a bridge when any of its configured ports
transitions from the Learning state to the Forwarding state.

The trap is sent by a bridge when any of its configured ports
transitions from the Forwarding state to the Blocking state.

Indicates that the packet drop due to the policy

Indicates that the packet has forward based on policy

An IGMP PROXY Table overflow.

An IGMP Message of v1 received on ifIndex.

One or more VRRP entries deleted due to IP interface deletion or transition.

Hot swap trap.

Informational trap indicating that a port is added to a trunk

This warning is generated when a port removed from a trunk.

Informational trap indicating that a port can not be added to
a trunk because of device limitations or diffrent swIfType.

Informational trap indicating that a locked port receive
a frame with new source Mac Address.

add gvrp dynamic vlan

remove gvrp dynamic vlan

vlan status was changed from dynamic to static

vlan status was changed from static to dynamic

Controller receive trap from member , and forward it as trap

Trap indicating the fan state.
rndErrorSeverity will be:
       0 for fan state  nomal, notPresent
       1 for fan state warning, notFunctioning
       2 for fan state critical
       3 for fan state fatal
The error text will specify the fan index, fan description and the exact fan state

Trap indicating the power supply state.
rndErrorSeverity will be:
       0 for power supply state  nomal, notPresent
       1 for power supply state warning, notFunctioning
       2 for power supply state critical
       3 for power supply state fatal
The error text will specify the power supply index, power supply description and the exact power supply state

Trap indicating the stack connection state
0 for stack state connected,
1 for stack state disconnected

Trap indicating that the temperature in the device has exceeded the
device specific safe temperature threshold.

Informational trap indicating that adding dynamic mac/s
failed due to full hash chain.

Informational trap indicating that port 802.1x status is authorized.

Warning trap is indicating that port 802.1x status is unAuthorized.

Warning trap is indicating port lock hase began.

Warning trap is indicating port lock has ended.

Warning trap indicating that the user was locked after
number of consecutives unsuccessful login attempts.

Warning trap indicating - Port was suspended because there was BPDU Guard violation.

Informational trap indicating that MAC authentication supplicant
is authenticated and is allowed to access the network.

Warning trap is indicating that Radius server rejects
MAC authentication supplicant.

Warning trap indicating - A loopback was detected on port.

Warning trap indicating - A loopback detection resolved on port.

Warning trap indicating - A port has been suspended by Loopback Detection.

Warning trap indicating - A port has been suspended by Any application.

Warning trap indicating - Special BPDU DB Overflow.

Warning trap is indicating that supplicant was logged out
Since the ports time-range state was changed to inactive.

Warning trap is indicating that altough ports time-range
Is active now, it can not start working in mode auto.

Warning trap indicating - Port has multiple LLDP remote link neighbours -
EEE operational state will be FALSE.

Warning trap indicating - Port has single LLDP remote link neighbour -
EEE operational can be TRUE.

Warning trap is indicating that supplicant quiet period timeout
is active now.

Informational trap indicating that stack member is upgrading
to the image or boot version of the stack controller.

Warning trap indicating that stack member is downgrading
to the image or boot version of the stack controller.

Automantic switchover to backup link because of main link fault.

Communication returened to main link.

Informational trap indicating that port in PD does not meet the inrush-current standard.

Informational trap indicating that Port (x) requires more power than it should require.

Informational trap indicating power negotiation resolved power in Watts.

Informational trap indicating power negotiation 4-Wire status.

Informational trap indicating power HW fail status.

Informational trap indicating power negotiation expired.

Warning trap indicating that port storm control rate limit is configured to minumum rate.

Informational trap indicating about backplane ethernet port resolution.

Informational trap indicating that gbic is now present on port (X).

Informational trap indicating that gbic is not present anymore on port (X).

Informational trap indicating that loss Diagnosed on port (X).

Informational trap indicating that loss isn't active anymore on port (X).

Warning trap indicating that port storm control occurs on a port.

Radius server accounting event trap.

Radius server authentication failure event trap.

Radius server authentication success event trap.

Trap indicating the redundant fan status change.

Informational trap indicating that 802.1x supplicant port status is authorized.

Warning trap indicating that 802.1x supplicant port status is unAuthorized.

Warning trap indicating that credential is changed, rejected or not updated.

Informational trap indicating Non POE Detected unit

Informational trap indicating CPLD update FW is in progress

The trap is sent by a bridge when any of its configured ports
transitions to new inconsistency mode.

The trap is sent by a bridge when any of its configured ports
transitions from inconsistency mode to resolved mode.

Warning trap indicating that non-compliant SFP is inserted on port (X).

Warning trap indicating power HW fail status on a port.

Warning trap indicating HTTP-TLS X.509 certificate validation error of
Common-Name/Subject-Alternative-Name

An attempt has been made to change <username|enable|line> password with wrong re-authentication credentials

Notification trap indicating invalid PoE single signature

Notification trap indicating invalid PoE double signature

Notification trap indicating denied PoE power

Notification trap indicating detected PoE SS BT port

Notification trap indicating detected PoE DS BT port

Notification trap indicating which PoE channel port is on

Notification trap indicating that the PoE BT port was demoted

Notify for any changes to device active or inactive image files

System clock has been updated

System clock has been updated by a different source

Summer-time has been updated

Time-zone has been updated

System clock source-list has been updated

HTTPS client has successfully established connection

HTTPS client has failed to establish connection

HTTPS client has terminated connection

HTTPS server session request succeeded

HTTPS server session request failed

HTTPS server session terminated

HTTPS server successful user authentication

An RX buffer overflow has occurred in one of the LAN or link
interfaces. The bound variable rndErrorDesc provides the
interface number.

SSH session request succeeded

SSH session terminated

Login Quiet mode is enabled

Login Quiet mode is disabled

Dying-gasp power failure notification

Warning trap is indicating that configuration of ASV TCAM rule is failed.

Warning trap is indicating that eFuse verification has failed.

Warning trap is indicating that eFuse Revocation has failed.

Warning trap is indicating that secure boot verification on copy has failed.

Warning trap is indicating that secure boot board type has failed.

Warning trap is indicating that secure boot image type has failed.

Warning trap is indicating that secure boot failed on sync image to Member Unit

Warning trap is indicating that secure boot failed to add incompatible unit

Warning trap is indicating that secure boot failed to add unit with revoked key

Warning trap is indicating that secure boot failed to add unit with non-revoked key

Warning trap is indicating that no system resource to configure Surveillance-Vlan CoS remark

Warning trap is indicating that no system resource to configure Voice-Vlan CoS remark

Warning trap indicates that CoA/PoD Packet is discarded. The reason is specified.

Warning trap indicates that CoA/PoD Packet is discarded. The reason is duplicated request.

Informational trap indicates that CoA/PoD Request is rejected. The reason is specified.

Warning trap indicates that CoA/PoD Request is rejected. The reason is NAS mismatch.

Informational trap indicates that CoA/PoD Request Server-key was not validated

Warning trap indicates that existing Request session was terminated. The reason is Request session overflow.

Warning trap indicates that 802.1x session for host mac-address on interface interface-id has been terminated by Disconnect-Request.

Warning trap indicates that 802.1x session for host has been terminated by Disconnect-Request.

Warning trap indicates that 802.1x re-authentication initiated for host by CoA Request.

Warning trap indicates that the interface suspended by CoA Request.

Warning trap indicates that the interface suspended for 10 seconds by CoA Request.

Warning trap on creating, changing or deleting a CoA client server-key.

Warning trap on creating, changing or deleting a CoA default server-key.

This trap indicates that in an OpenGate IPX RIP table overflow.
The bound variable rndErrorDesc, rndErrorSeverity
provides the actual  message text and severity respectively.

This trap indicates that in an OpenGate IPX SAP table overflow.
The bound variable rndErrorDesc, rndErrorSeverity
provides the actual  message text and severity respectively.

Interport queue overflow has occurred in one of the LAN or link interfaces.
The bound variable rndErrorDesc provides the interface number.

This trap indicates that message that fits FACS statenebt with
operation blockAndReport was forward to the interface. The bound
variable rndErrorDesc, rndErrorSeverity(== info ) and
interface Number.

An overflow condition has occurred in the Routing Table. The Routing
Table is used for IP routing algorithm (RIP).

This trap indicates that auto comfiguration completetd succssefully.
The bound variable rndErrorDesc, rndErrorSeverity(== info )

This trap indicates that an overflow condition has occurred in the
layer II Forward Table.
The bound variable rndErrorDesc, rndErrorSeverity(== warning )

This trap indicates that a connection establish between the Frame
relay Switch and the WanGate.
The bound variable rndErrorDesc, rndErrorSeverity(== warning )

This trap indicates that a connection between the Frame Relay Switch
and the WanGate failed.
The bound variable rndErrorDesc, rndErrorSeverity(== warning )

This trap indicates that the an error occured during initialization
The bound variable rndErrorDesc, rndErrorSeverity(== error )

This warning is generated when an overflow occurs in the clients table.

This warning is generated when a server does not respond to the dispatchers polling
and is thought to be inactive.

The Zero Hop Routing connections Table has been overflown.

The requested static connection was not accepted because there is
no available IP virtual address to allocate to it.

The virtual IP address appeared as a source IP.
All the connections using it will be deleted and
it will not be further allocated to new connections.

The source IP address sent an ARP specifying a virtual IP
which was not allocated for this source.
This virtual IP will not be allocated to connections of this
specific source IP.

An incoming SNMP SET request was rejected because no such
requests (except action requests) are accepted after start of
new configuration reception or during sending the current
configuration to an NMS.