Indicates that the SFP fault has cleared

Indicates that the SFP fault is active

Indicates that the multiple uplink alarm has cleared

Indicates that multiple uplinks have been detected

Indicates that the ExtA timing failure has been cleared

Indicates that the ExtA timing has failed

Indicates that the ExtB timing failure has been cleared

Indicates that the ExtA timing has failed

Indicates that the loss of heartbeat alarm cleared

Indicates that the loss of heartbeat alarm is active

Indicates that the primary and/or secondary timing source alarm has cleared

Indicates that the loss of network STP alarm cleared

Indicates that the loss of network STP alarm active

Indicates that the duplicate node alarm has been cleared

Indicates that the duplicate node alarm is active

Indicates that the duplicate SCM IP address alarm has been cleared

Indicates that the duplicate SCM IP address alarm is active

Indicates that the Bandwidth full alarm has been cleared

Indicates that the Bandwidth full alarm is active

Indicates that the primary timing source alarm has cleared

Indicates that the primary timing source has failed

Indicates that the primary and/or secondary timing source has failed

Indicates that the secondary timing source alarm has cleared

Indicates that the secondary timing source has failed

Indicates that the shelf's node number has been provisioned and is not zero.

Indicates that the shelf's node number has not been provisioned.

Indicates that the SM's failure to communicate the Internal Management VLAN to an access module has cleared.

Indicates that the SM has failed to communicate the Internal Management VLAN to an access module.

that either there is no hardware incompatibility among the  SM cards 
and SMIO Or ERPS/CSLAG is not provisioned.

that attempts for provisioning of ERPS or CSLAG is made and hardware incompatibility detected 
among SM and SMIO

that the AM is out of Backplane Rate Fallback mode.
adGenSlotInfoIndex indicates the slot of the card sending the alarm,
which is always the active SM.
ifIndex indicates the associated backplane port interface at
fault.

that the AM is in Backplane Rate Fallback mode.
adGenSlotInfoIndex indicates the slot of the card sending the alarm,
which is always the active SM.
ifIndex indicates the associated backplane port interface at
fault.

Indicates ring generator alarm clear

that the link status of the high speed peer interface between redundant switch modules is up.
ifIndex indicates the associated peer port interface

that the link status of the high speed peer interface between redundant switch modules is down.
ifIndex indicates the associated peer port interface

Indicates that the Backplane Incompatible alarm has been cleared.

Indicates that SM cards are not capable of full backplane speeds to some slots in the chassis.

Indicates that the ring generator has failed

Indicates that the power limit alarm has cleared

Indicates that the shelf power limit has been exceeded

Indicates that the unknown SFP alarm has cleared

Indicates that the unknown SFP alarm is active