This MIB defines information as per wireless AC and tunnel between
AP and AC.
If NMS intends to get more detailed information for the AP and AC,
it could refer entPhysicalIndex in the Entity MIB to get entity
information.
GLOSSARY
IEEE 802.11
Standard to encourage interoperability among
wireless networking equipment.
Access point (AP)
Transmitter/receiver (transceiver) device
that commonly connects and transports data
between a wireless network and a wired network.
Access control (AC)
To control and manage multi-APs, it will bridge
wireless and wired network.
Radio
The chip set to receive and send wireless signal.
Fat AP
Applied in the home, SOHO and so on, and it could
independently work without help from AC.
Fit AP
Applied in the enterprise environment, it will work
under the control and management from AC.
Control And Provisioning of Wireless Access Points Protocol
The short name of protocol is CAPWAP. AC will control
and manage AP by CAPWAP tunnel protocol defined by IETF.
Also, a data tunnel will be set up between AC and AP.
Basic Service Set
The IEEE 802.11 BSS of an AP comprises of the
stations directly associating with the AP. It will
be identified by BSSID.
ication is sent by AC when CAPWAP tunnel becomes up.
By this way, NMS will immediately know tunnel up event.
It is unnecessary to identify whether it is control or data
tunnel.
h3cDot11ACMtTunnelDownTrap
.1.3.6.1.4.1.43.45.1.10.2.75.1.3.0.2
ication is sent by AC when CAPWAP tunnel becomes down.
By this way, NMS will immediately know tunnel down event.
It is unnecessary to identify whether it is control or data
tunnel.
h3cDot11ACMtBackupSwtTrap
.1.3.6.1.4.1.43.45.1.10.2.75.1.3.0.3
is sent by AC when AC switches from master to slave
or from slave to master.
h3cDot11ACLoadBalanceTrap
.1.3.6.1.4.1.43.45.1.10.2.75.1.3.0.4
This trap is sent by AC when load-balance is enabled on AC.
h3cDot11ACStaFullTrap
.1.3.6.1.4.1.43.45.1.10.2.75.1.3.0.5
This notification will be sent when STA is full on AC.
h3cDot11ACStatusSwitchTrap
.1.3.6.1.4.1.43.45.1.10.2.75.1.3.0.6
ication will be sent when AC switchs from standby to active
or from standby to active.